Chapter
Installing the RMX 1500
For detailed instructions, precautions and requirements for installing the RMX 1500 refer to the Polycom RMX 1500 Hardware Guide.
The following procedures have to be performed to install the RMX 1500 in your site:
•Unpacking the RMX 1500
•Installing the RMX in a rack or as a standalone
•Connecting the RMX 1500 to the power source
•Connecting the network (LAN, IP and ISDN) cables to the RMX.
Unpacking the RMX 1500
To unpack and lift the RMX 1500:
1When you receive the RMX 1500 packing case, inspect the equipment for damage and verify that the components match the packing slip.
2Open the top cover of the packing case.
Two boxes are placed on the top Stratocell®, labelled:
—Installation Accessories. This kit contains the power cables and a
—Rack Installation Accessories. This kit contains the accessories for the 19”/23” racks as follows:
Write down the RMX’s serial number that is on a sticker on the back of the unit. It will be needed for product registration later in the process.
Table
Item ID | Description | Quantity |
|
|
|
Chassis runners (60cm in length) | 2 | |
| suitable for installation within 60cm of |
|
| inter spaces |
|
| The chassis runners are required |
|
| when mounting the RMX 1500 on |
|
| 19”/23” racks. |
|
|
|
|