Polycom RMX 4000 Hardware Guide
2-15
5On the card to be installed, m ove the ejector levers to their fully open
position.
6Slide in the replacement RTM ISDN card.
7Insert the card into the slot until the ejector levers touch the front
edge of the card cage.
8Push the ejector levers to their fully closed position.
9Tighten the captive screws on each side of the rear panel of the card,
securing the RTM ISDN card to RMX.
10 Connect the RJ-45 terminated PRI cables into any of the slots labeled
PRI1 - PRI12:
7 E1 or 9 T1 cables can be connected to each RTM ISDN card, up to a
total of 1 4 E1 or 1 8 T1 PRI cables when a m aximum of two R TM ISDN
cards are installed.
PRI Cables