RSS 2000 Getting Started Guide & Release Notes – Version 3.0.2
First Time Installation and Configuration
Preparations
Obtain the following information from your network administrator:
•RSS 2000 unit, Subnet Mask and Default Gateway IP addresses
•Gatekeeper IP address, Prefix, and E.164 of the RSS 2000.
Unpacking and Installing the RSS 2000
1Place the RSS 2000 unit on a stable flat surface in the selected location.
2To connect to the power source, insert the power cable into the Power connector on the rear panel of the MGC+ unit and insert the Power cable into the power source socket.
3Connect the LAN cable to LAN1 in the back of the system.
4Turn on the power switch.
Initial RSS 2000 IP Configuration
The system is shipped with a default IP configuration:
IP Address:192.168.1.254
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
There are two ways to change the initial IP address of the sytem:
•Via a cross over LAN cable
•Via a RS232 or Telnet Console.
Changing the initial IP address via a cross over LAN cable
1Connect a cross over LAN cable to LAN1 in the RSS 2000.
2Set your laptop to the same segment of the RSS For example (in your laptop IP config setting):
2
