CUTTING THE TAILS

Cut the tail board (drawer side) similar to cutting the rabbeted half-blind dovetail, but remove the spacer and move the left offset guide directly against the tail board.

NOTE: Support the template with a scrap workpiece thick enough to prevent the cutter from contacting the base.

CUTTING THE PINS

Cut the pin board (drawer front) similar to cutting the rabbeted half-blind dovetail. (If you use the alternate method of aligning the pin board with secondary board. Make sure the secondary board does not have a rabbet).

NOTE: Ensure that the pin board (drawer front) is thicker than the depth of cut to prevent the cutter from contacting the base.

FITTING THE JOINT

Fit the joint the same as you would a standard rabbeted half-blind dovetail.

NOTE: If a change in depth-of-cut is required, change it on both bits.

BOX JOINT BITS

You can make box joints with different diameter router bits for the two workpieces. The process is identical to making standard box joints except that you will need to change the bit for the second board. Two routers will make this job easier. However, this two-router method will require two 3/4" OD template guides and two template guide lock nuts, available from Porter-Cable.

In selecting straight bits for these modified box joints, keep in mind the following:

1.The sum of the diameters of the two straight bits must equal 1".

2, The length of the bit used to cut the first board determines the maximum thickness of the second board. (Example: if a 3/8" diameter bit used on the first board has a 1/2" long cutter, the maximum thickness of the second board would be 1/2").

BOX JOINT BITS (READILY AVAILABLE)

 

LARGER STRAIGHT BIT

 

SMALLER STRAIGHT BIT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1/2"

 

 

 

 

 

1/2"

 

 

 

 

9/16"

 

 

7/16"

 

 

 

 

5/8"

 

 

3/8"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SLIDING DOVETAIL BITS

Any dovetail bit can be used to make sliding dovetails as long as the bit does not cut into the template guide or the base of the jig. The process is identical to that of the standard sliding dovetail. Also, you can use template guides smaller than 3/4" OD which will have the effect of making the dado slot wider than the bit diameter.

NOTE: Any template guide bushing surface must not extend more than 1/4" from the base.

16