Loosen base locking screw and move motor unit up or down to decrease or increase depth of cut.
It may be necessary with some bits to withdraw bit from collet to obtain maximum depth of cut. When doing this be sure at least 1/2" of bit shank is engaged in collet. Do not use bits that result in having less than 1/2" of bit shank engaged in collet. To do so may cause poor gripping of collet resulting in loose bit and damage to work, or personal injury should the bit come out of collet.
ADJUSTING TILT
1.Loosen two tilt locking screws (C) Fig. 6, (one on each side of base) using wrench provided.
2.Tilt base aligning index mark (D) Fig. 6, with desired angle and tighten securely.
3.Make a trial cut on scrap material to check alignment. Readjust if necessary.
MODEL 7312 OFFSET TRIMMER ASSEMBLY
Model 7312 Offset Trimmer is completely assembled at the factory. The offset base is assembled to Model 7301 Motor as outlined below. Model 7312 Offset Trimmer can be disassembled by reversing the following assembly instructions.
ASSEMBLING OFFSET BASE TO MOTOR
DISCONNECT TOOL FROM POWER SOURCE.
1.Remove collet nut and collet from motor unit.
2.Assemble drive pulley (A) Fig. 7, to motor spindle and tighten securely.
3.Use a phillips screwdriver to remove the three
4.Position the base to the motor and drive pulley assembly (from step 2). Be sure that the motor drive pulley engages the drive belt (inside the base housing).
5.Secure the motor to the base (see Fig. 9), with the thumbscrew (A), spring (B), and washer (C).
6.Locate the
A
AA
A
Fig. 7 | Fig. 8 |
15
