INVERTED
3/16"
➤
➤
Fig. 12
OPERATION
1.Material to be trimmed must overhang the base material by at least 1/8".
2.
Always wear safety glasses while operating a laminate trimmer.
3.
DISCONNECT TOOL FROM POWER SOURCE.
4.Firmly grasp motor housing being sure switch is in the “OFF” position.
5.Verify bit is clear of foreign objects and cord will not “hang up” on any obstructions.
6.Be sure workpiece is firmly held in place. Use clamps where necessary to secure workpiece.
7.Plug in power supply cord. Be alert to resist starting torque of motor. Turn motor “ON”.
8.Allow motor to reach “full speed”. Place base of trimmer on surface to be trimmed and feed into work until bit pilot contacts base material. When guiding on a previously laminated surface, always wax or lubricate the area that trimmer will guide against.
NOTE: While operating trimmer with tilt base at any tilt setting other than “0” degrees, the long side of the
base must be kept perpendicular to the piloting surface to prevent possible work spoilage.
9.Feed from left to right with a smooth
steady motion (See Fig. 13).
10.At completion of trimming operation, turn switch “OFF”. Allow motor to come to a complete stop before laying trimmer down.
Fig. 13
17
