4.Adjust guide until hole in gauge fits over stud on end of gauge. Tighten all screws securely.
5.Remove guide setting gauge from trimmer and install the bit as outlined under TO INSTALL BIT.
NOTE: It will be necessary to separate motor from base to remove setting gauge and install bit.
6.Adjust depth of cut so that the straight portion of bit extends below trimmer base at least equal to the thickness of material to be trimmed.
7.Make a trial cut on scrap material to check alignment. Readjust if necessary.
BEVEL TRIMMING WITH PILOTLESS BIT WITH 3/8" LENGTH FLUTE
1.Follow steps 1 thru 5 under the previous section, except install bevel trimming guide (C) (Fig.4). This guide may be identified by the Letter “B” molded on.
2.Adjust depth of cut so that only the bevel portion of the bit extends below trimmer base at least equal to the thickness of material to be trimmed.
3.Make a trial cut on scrap material to check alignment. Readjust if necessary.
USING STRAIGHT EDGE GUIDE
The Straight Edge Guide (D) (Fig. 4) may be used with either 44858PC or a pilotless bit with 3/8" length flute for trimming long straight edges.
Assemble to guide base and adjust similar to other guides.
MODEL 7319 TILT BASE TRIMMER ASSEMBLY
Model 7319 Tilt Base Trimmer is completely assembled at the factory. The base is assembled or removed from Model 7301 motor with base locking screw (A) Fig. 6.
NOTE: There is a flat washer (B) Fig. 6, on the locking screw.
Model 7319 Tilt Base is designed for use with 43216PC flush trim bit for trimming into corners. It may also be used with other “self pilot” trim bits for conventional trimming at 90° setting.
ADJUSTING DEPTH OF CUT
DISCONNECT TOOL FROM POWER SOURCE.
C D
A B
Fig. 6
14
