Porter-Cable 7414 instruction manual To Install Sanding Disc, To Install Wheel Guard Accessory

Fig. 2

283800 - 07-31-00.QXD 9/23/02 1:34 PM Page 8

INSTALLATION:

1.Insert threaded end of handle into handle clamp (A) Fig. 1A.

2.Turn handle clockwise and tighten securely.

CHANGING POSITIONS:

1.Loosen handle by turning 2 full turns counterclockwise.

2.Push in on handle and move handle to

desired location.

3. Release handle. D

4.Retighten securely.

TO INSTALL SANDING DISC

1.CAUTION: DISCONNECT MACHINE

FROM POWER CIRCUIT.		A
2.	Rest machine on its back with spindle	B
facing up.
3.	Position inner flange (B) Fig. 2, onto	C
spindle (A), with round hub facing outward,
away from machine. Rotate flange until it drops
into place on the spindle.		E

4.Place back-up pad (C) Fig. 2, onto spindle

and rotate clockwise until seated. F

5.Depress spindle lock button (D) Fig. 2,

rotate back-up pad (C) clockwise until spindle

lock engages, and firmly tighten back-up pad. Continue to depress spindle lock button.

6.Place sanding disc (E) Fig. 2, on back-up pad and center it.

7.Place retaining nut (F) Fig. 2, through hole in sanding disc. Tighten securely by turning clockwise.

TO INSTALL WHEEL GUARD (ACCESSORY)

There are 7" or 9" TYPE 27 wheel guards available as accessories. (See the ACCESSORIES Section of this manual for specific applications). Both guards are installed and adjusted in the same manner.

WARNING: Always use an approved, and properly adjusted wheel guard where required (see

ACCESSORIES Section of this manual).

1.	CAUTION:	DISCONNECT
MACHINE FROM POWER CIRCUIT.			A
2.	Rest machine on its back with
spindle facing up.
3.	Seat guard onto mounting flange.
Rotate the guard to a position that
will place the guard between the
operator and the grinding wheel (or
other accessory requiring a guard).			Fig. 3
Tighten clamp screw (A) Fig. 3, to

secure the guard in proper position.

8