D.Slide the collar (B) off the standard hose and position it onto the Static Dissipating hose.
E.Thread the mounting hub (C) onto the Static Dissipating hose (by turning it counterclockwise).
F.Place the bayonet connector onto the mounting hub and position the collar (B), so that its locking tabs align with the holes in the bayonet connector.
G.Press the collar into the bayonet connector until the two locking tabs engage the holes in the bayonet connector.
9.Attach the Vacuum Hose to the appropriate accessory nozzle, or to the dust port of a power tool.
OPERATING INSTRUCTIONS
The
A power outlet is provided that allows a power tool to be connected to the Vacuum Cleaner. The Vacuum Cleaner will automatically switch “ON” when the power tool is started, and it will automatically switch “OFF” approximately 6 to 10 seconds after the power tool is turned “OFF”.
POWER SWITCH
The power switch on both the 7812 and 7814 models has two positions – on and off. When not using a power tool, turn the vacuum cleaner to the “ON” position to begin vacuuming.
These vacuums can be used to provide a
An accessory outlet is located under a hinged cover (A) Fig. 5 on the front of the vacuum cleaner. Lift this cover to expose the outlet.
Connect the power cord of the power tool to this outlet. Turn the power switch of the vacuum cleaner to the “ON” position. A green light, located next to the outlet, will glow. This light indicates that the vacuum will start automatically when the power tool is activated.
When the power tool is switched to the “OFF” position, the vacuum motor will continue to run for 6 to 10 seconds to finish collecting the dust, and then it will stop.
A
Fig. 5
7
