MAINTENANCE
When performing maintenance, you
may be exposed to hot surfaces, water pressure, or moving parts that can cause serious injury or death!
PUMP
NOTE: The pump was filled with oil at the factory.
1.Change pump oil after the first ten (10) hours of operation and every fifty (50) hours thereafter.
Before performing any maintenance or repair, disconnect spark plug wire, let engine cool and release all water pressure. The engine contains flammable fuel. DO NOT smoke or work near open flames while performing maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine maintenance schedule should be prepared and followed. If the pressure washer is used in unusual conditions, such as high-
To Check Oil:
1.Remove dipstick/oil plug from pump and wipe clean.
2.Insert dipstick/oil plug fully into pump, then remove it.
Dipstick/oil plug
Oil Drain Plug
temperatures or dusty conditions, more frequent maintenance checks will be required.
3.Oil level is correct when oil covers the lower 1/2 inch of end of dipstick/oil plug.
ENGINE
Consult the Engine Owners Manual for the manufacturer's recommendations for any and all maintenance. NOTE: The frame is equipped with an oil drain hole to help make changing the engine oil easier.
How To Change Pump Oil
1.Loosen dipstick/oil plug.
2.Place a container under the oil drain plug.
3.Remove oil drain plug.
4.After oil is drained replace oil drain plug. Tighten securely.
5.Remove dipstick/oil plug and fill with 13.5 oz (399 ml) of 30W non detergent oil.
6.Replace dipstick/oil plug and tighten securely.
A09608 | 14- ENG |
