OPERATION
KNOW YOUR GENERATOR
Read this General Manual and Safety Rules before operation of your Generator. Compare the illustration in your parts manual with your generator to familiarize yourself with the location of various controls and ad- justments. Save all manuals for future references.
GENERATOR CAPACITY
IMPORTANT: Exceeding the rated capacity of your generator can result in serious damage to your genera- tor and connected electrical devices. See the Wattage Calculation section in this manual to assist you in de- termining the appliances and tools that can be ran with the wattage capacity of your generator.
CIRCUIT BREAKERS
Each receptacle has a circuit breaker to protect the generator from overloading. If the circuit breaker trips, unplug all electrical loads from the generator. Let the circuit breaker cool down. Push circuit breaker button to reset.
LOW OIL SHUTDOWN
Your generator engine is equipped with Low Oil Shutdown. Low Oil Shutdown is a safety device designed to protect your engine from damage in the event the oil level in the crankcase is low.
If while the engine is running, the oil gets low, it will automatically shut itself down and will not restart until the oil is added. If the oil is low before
NOTE: The Low Oil Shutdown mechanism is very sen- sitive. You must fill the engine to the full mark on the dipstick to inactivate this safety device.
IDLE CONTROL
Choose the correct application.
1.For normal application such as power tools, small electric appliances, light bulbs, and radios:
Place the idle control switch in the ON position. The generator will idle down when there is no load. This lowers the engine noise, saves on fuel consumption, and engine life.
2.Idling down IS NOT recommend on large motors (refrigerators, freezers, etc) or voltage sensitive electronic equipment (computers, tel- evisions, etc). For these applications:
Place the idle control switch in the OFF position.
12V DC OUTLET
IMPORTANT: Allow generator to run at no load for 5 minutes upon each initial
To charge battery:
1.Using the battery cables supplied, connect the red positive (+) battery cable to the battery's posi- tive (+) terminal.
2.Attach the other end of the red positive (+) battery cable to the generators (+) 12V DC outlet.
3.Connect the black negative
4.Attach the other end of the black negative
5.Charge the battery according to battery or equip- ment manufacturer recommendations.
To operate 12V DC equipment:
1.Refer to the 12V DC equipment owner's manual for operation of equipment and any special cable or adapter requirements.
11 — ENG
