Porter-Cable H451CS instruction manual Storage, Engine Preparation, Generator

Models: H451CS

1 20
Download 20 pages 18.08 Kb
Page 15
Image 15
STORAGE

STORAGE

If you are going to store your generator for more than 30 days, use the following information as a guide to prepare the generator for storage.

Never store generator with fuel in the tank in- doors or in enclosed, poorly ventilated areas, where fumes can reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or other gas appliances.

Engine Preparation

1.Add fuel stabilizer to fuel tank to minimize the for- mation of fuel gum deposits during storage.

2.Run engine at least 5 minutes after adding stabiliz- er to allow it to enter the fuel system.

3.Next shut off engine.

4.Disconnect the spark plug wire and remove the spark plug.

5.Add one teaspoon of oil through the spark plug hole.

6.Place rag over spark plug hole and pull the recoil a few times to lubricate the combustion chamber.

7.Replace the spark plug, but do not connect the spark plug wire.

NOTE: If a fuel stabilizer is not used, all gasoline must be drained from the tank and carburetor to prevent gum deposits from forming on these parts and causing possible malfunction of the engine.

Generator

Clean the generator as outlined in the Mainte- nance Section on this manual.

Check that cooling air slots and openings on gen- erator are open and unobstructed.

15 — ENG

Page 15
Image 15
Porter-Cable H451CS instruction manual Storage, Engine Preparation, Generator