ADJUSTMENTS
DEPTH OF CUT ADJUSTMENTS
See Figures 4, 5, 6, and 7.
We recommend that cuts be made at a depth not exceeding 1/8 in. (3 mm) and that several passes be made to reach depths of cut greater than 1/8 in. (3 mm).
■Unplug your router.
WARNING:
Failure to unplug your router could result in accidental starting causing serious injury.
■Place your router on a flat surface, unlock clamping lever, and turn depth adjusting ring until cutter is inside subbase. See Figures 4 and 5.
■Turn the depth adjusting ring until tip of cutter touches flat surface (zero depth of cut). See Figure 6. Next turn depth indicator ring until the zero lines up with the indi- cator point on front of motor housing. See Figure 5.
■Position your router so that the cutter can extend below the subbase for desired depth setting.
■Turn the depth adjusting ring to obtain the desired depth of cut. The distance the cutter moves can be read on the depth adjusting ring. Each mark on the depth adjusting ring indicates 1/64 in. (0.4 mm) change in depth setting. One indicator point is located on front of the motor housing, the other one is located on the base.
■Lock clamping lever, securing depth adjusting ring to motor housing and base.
DEPTH OF CUT ADJUSTMENTS WHEN ROUTER IS MOUNTED TO A ROUTER TABLE
See Figure 7.
The depth of cut is readable from both sides of the depth adjusting ring. There is a depth indicator ring and indicator point on both sides of the depth adjusting ring. The bottom ring is convenient when using your router mounted to a router table. The indicator point on the base should also be used when using your router mounted to a router table.
The depth indicator rings are identical parts. Therefore, when you have your router mounted upside down on a router table, you set depth of cut by reading the scale different. Set the cutter at zero depth of cut, rotate depth indicator ring to desired depth of cut on the scale, then turn depth adjusting ring back to zero depth of cut and lock clamping lever securely.
DEPTH
INDICATOR
RING
INDICATOR
POINT
DEPTH
ADJUSTING
RING
CUTTER | SUBBASE | Fig. 5 |
INSIDE SUBBASE |
CUTTER AT | Fig. 6 |
ZERO DEPTH OF CUT | |
FOR ROUTER TABLE USE ONLY |
|
| CLAMPING |
TO | LEVER |
LOCK |
|
LOC
K
UN
TO 
UNLOCK
| K |
C | |
LO |
|
BASE
DEPTH
INDICATOR
INDICATOR | RING |
POINT |
|
Fig. 4 | Fig. 7 |
Page 9
