b). For CR4001/ 4101/ 4211/ 4002/ 4102/ 4212:
c). For CR4003/ 4103/ 4213:
d). For CR4004/ 4104/ 4214: The serial signal cable is already built on.
e). For CR4005/ 4105/ 4215/
6.Power Source depend on model
a). For
b). For
c). For CR4004/ 4104/ 4214: Power connector cable and I/O bracket plate.
INSTALLATION
CR4000 / 4100 / 4210 Connect the drawer to POS system/printer as shown below:
Rear View | 8P Telephone Plug |
Control signal input
Ground
8P Telephone Jack | CASH DRAWER |
CR4001 / 4101 / 4211 | With Printer Interface |
|
POS System or Printer
Output to drawer
6P Telephone Plug
1).Connect the drawer serial I/P port to the computer COM port. Connect the power adapter output to the Power Input jack
2).No other RS232C devices should be connected to the serial O/P port.
3).Set position 3 of S2 to OFF and position 4 of S2 to ON. Please refer to rear panel illustration.
CR4002 / 4102 / 4212
1).Connect the drawer serial I/P port to the computer COM port. Connect the power adapter output to the Power Input jack.
2).Other RS232C device can be connected to the serial O/P port when needed as long as the security code makes no influence to this RS232C device.
3).Set position 3 of S2 to ON and position 4 of S2 to OFF. Set S1 for security code to open cash drawer. In normal practice, the security code is suggested to be a
CR4003 / 4103 / 4213
1).Connect the drawer parallel I/P port to the computer LPT port. Connect the power adapter output to the Power Input jack.
2).Other parallel device such as a printer can be connected to the parallel O/P port when needed as long as the Security code makes no influence to this parallel device.
3
