INSTALLATION GUIDES
CAUTION: Before any installation or cable connection to the set, please always make certain that the system is turned off and the external power source to the set is removed to prevent electric hazard! Never touch any metal pin in the connectors or circuits to avoid high voltage hazard or electrostatic discharge damage unless the operator is well grounded. Failure to do the above will void the product warranty!
OPENING CABLE COVER
Please follow steps A to C sequentially with reference to pictures below to remove the cable cover for both slim and universal base models.
B 
B
A 
A 
CC
Step A: Push lock/release lever for tilt angle adjust backward
Step B: Turn panel to most horizontal position
Step C: Pull at the removal hollow toward the user
DISCONNECTING ALL CABLES
After removal of the cable cover, the connector area will be accessible then. Please first note orientations of every existing cable connection and then disconnect every cable properly before separating the main unit from the adjustable stand assembly. Please note that the click lock spring has to be pressed down prior to pulling out the connector such as the LAN port. Please also note that the fixing screws have to be loosened free prior to disconnection such as the COM ports or the LPT port. Please always hold the connector head instead of pulling on the cable wire when disconnecting any connector. Failure to do this could damage the cable and jack that is considered as an artificial destruction. Damages due to incorrect disconnection operation are not covered by product warranty!
Part 7
