Poulan 20112X92E1, 20112X92E0 Assemble Wheels, Assemble Upper Handle, Assemble Upstop Bracket

1.Position lower handle on housing so cut-off flat is forward as shown.

2.Align holes in handle with holes in housing as shown and assemble 3/8- 16 x 3/4 hex bolts, flat washers, and locknuts. Tighten securely.

3.Repeat for opposite side of mower.

Flat washers Locknuts

Lower handle

Hex bolts

ASSEMBLE WHEELS

Cutting height is determined by assem- bling the wheels in one of four possible positions on the mower housing. All wheels must be in the same height posi- tion for even cutting.

1.For each wheel, assemble shoulder bolt and spacer as shown.

2.Assemble 1-1/4" diameter washers (rear wheels only) and 3/8-16 locknuts on inside of mower housing and tighten securely.

1-1/4" diameter Washer (Rear wheels only)

Mower housing

Cut-off flat forward

ASSEMBLE UPPER HANDLE

1. Position upper handle over lower

handle with small hole for mounting

up-stop bracket to right side and as-

semble 1/4-20 x 1-1/2 hex bolts and

Shoulder bolt

Spacer

3/8-16 Wheel Locknut

1/4-20 locknuts. Tighten securely.

ASSEMBLE UPSTOP BRACKET

2.Position upstop bracket on the right inside of upper handle as shown.

3.Install the hex washer head screw into the hole in up-stop bracket and upper handle. Tighten securely.

AS VIEWED FROM FRONT OF MOWER

Up-stop bracket

Hex bolts

Hex washer head screw

Lock nuts

ASSEMBLE DISCHARGE GUARD

1.Place discharge guard on top of lawn mower discharge opening.

2.Install two (2) 1/4-20 x 3/4 hex bolts through housing and discharge guard.

3.Install two (2) 3/4" diameter washers and two (2) 1/4-20 locknuts. Tighten securely.

Locknuts

Washers

Discharge guard

Hex bolts

7