OPERATION
MUFFLER
GASOLINE
FILLER CAP
CHOKE
CON-
TROL
SAFETY IGNITION
KEY
ELECTRIC | AUGER | DEFLECTOR REMOTE | TRACTION DRIVE |
START | CONTROL | ||
BUTTON | LEVER | CONTROL LEVER | CONTROL LEVER |
|
| DRIVE SPEED |
|
POWER |
| CONTROL LEVER |
|
CORD |
|
|
|
PLUG |
|
|
|
| CHUTE |
|
|
DEFLECTOR |
|
| |
|
|
| LIGHT |
ON / OFF
SWITCH
PRIMER
FUEL
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
DISCHARGE
CHUTE
TOOL
FIG. 8
DISCHARGE CHUTE CONTROL KNOB
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control knob - used to change the direction the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
8