Spacer, Retainer, Knob RED, Handle Knob | Poulan 96192004602

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PR8P27ES (96192004602)

HANDLES

10

					2
11			4	7
		8		7
		8
		9
	7 5	9
6	7 5
6				1
				1
3				13
8				13
8
		13			12
		13			14
					14
				14
			12		01.08.002-G
	KEY	PART	DESCRIPTION
	NO.	NO.	DESCRIPTION

1412683X431 CONTROL PANEL

2424517X431 CONTROL LEVER LH

3424516X431 CONTROL LEVER RH

4412679X008 TRACTION ROD ARM

5426918X008 IMPELLER ROD ARM

6412677 INTERLOCK ROD

7	421613	SPACER
8	169675	RETAINER
9	17060410	SCREW 1/4-20 X .62
10	414280	KNOB BLACK
11	414281	KNOB RED
12	178899	HANDLE KNOB
13	19131316	WASHER 3/8
14	72120618	CARRIAGE BOLT 3/8-16 X 2.25

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 29

Image 29

Poulan 96192004602, 438371 owner manual Spacer, Retainer, Knob RED, Handle Knob, Washer 3/8

Contents

Snow Thrower Model Number Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents HOW to SET UP Your Snow Thrower Assembly / PRE-OPERATIONParts Packed Separately in Carton Remove Snow Thrower from Carton Unfold Upper Handle Install Speed Control ROD See FigsInstall Traction Drive Control ROD See Figs Install Discharge Chute / Chute Rotater Head See Fig Install Auger Control ROD See Figs Check Tire Pressure Install Chute Deflector Remote Control See Figs Know Your Snow Thrower OperationPrimer Ignition KEY Recoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow ThrowerTo USE Choke Control See Fig To Control Snow Discharge See Fig Power Steering Operation See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig To Move Forward and Backward See Fig Before Starting the Engine To Adjust Skid Plates See FigScraper BAR See Fig Check Engine OIL Level See Fig To Start Engine Snow Throwing TipsBefore Stopping If Recoil Starter has Frozen General Recommendations MaintenanceBefore Each USE Lubrication Engine Cleaning To Adjust Snow Thrower Height Service and AdjustmentsChute Deflector Shear Bolts See Fig To Replace Belts See Fig To Remove Wheels See Fig To Adjust Cable Tension See FigCarburetor Engine Speed Other StorageFuel System Engine OIL Troubleshooting Service Notes Exploded KEY Part Description Scraper BAR Auger HousingAuger Bearing Bearing Plug Auger 27 RH Auger 27 LHSkid Plate LH Skid Plate RH Knob Black Deflector SealPOP Rivet Chute Snow Shield 419822X431 Shield Retainer Strap KEY Part Loop Handle RH Loop Handle LH419797X431 Lower Handle Retainer SpacerKnob RED Handle Knob Carriage Bolt 5/16-18 X 155377 NUT 5/16-18 169675 Console Panel Wire HarnessHeadlight Bezel Flood Headlight Repair Parts Snow Thrower - Model Number PR8P27ES Drive Drive Plate Assembly Speed Selector AssemblyWheel HUB END Plate Sprocket Axle Shaft Frame ENGINE, B&S436146X421 Engine Mounting Plate 428684 Wheel Driver CoverWheel Lobe Clutch Slide Cable Bracket RH Wheel Assembly LHCable Bracket LH 193071 Safety Ignition KEY DECAL, DANGER, Deflector 181037DECAL, Danger Service Notes Service Notes Service Notes Limited Warranty