FUELING ENGINE
This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality
recommend FRIGIDAIRE HOME PRODUCTS brand oil. If you do not use this oil, use a good quality
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubri- cation. Lubrication is provided by the auto- matic oiler system when the oil tank is kept filled. Lack of oil will quickly ruin the bar and chain. Too little oil will cause overheating shown by smoke coming from the chain and/ or discoloration of the bar.
In freezing weather oil will thicken, making it necessary to thin bar and chain oil with a small amount (5 to 10%) of #1 Diesel Fuel or kerosene. Bar and chain oil must be free flowing for the oil system to pump enough oil for adequate lubrication.
Genuine POULAN or POULAN PRO bar and chain oil is recommended to protect your unit against excessive wear from heat and friction. POULAN or POULAN PRO oil resists high temperature thinning. If POULAN or POULAN PRO bar and chain oil is not available, use a good grade SAE 30 oil.
SNever use waste oil for bar and chain lu- brication.
SAlways stop the engine before removing the oil cap.
Oil Cap |
|
| Fuel mix cap | |||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
WARNING: The chain must not move when the engine runs at idle speed. If the chain moves at idle speed refer to
within this manual. Avoid contact with the muffler. A hot muffler can cause serious burns.
To stop the engine move the switch to the STOP or OFF position.
To start the engine hold the saw firmly on the ground as illustrated below. Make sure the chain is free to turn without contacting any object.
SMove switch to the START or ON posi- tion.
Use only
Hold saw firmly while pulling starter rope
Important points to remember
When pulling the starter rope, do not use the full extent of the rope as this can cause the rope to break. Do not let starter rope snap back. Hold the handle and let the rope rewind slowly.
For cold weather starting, start the unit at full choke; allow the engine to warm up be- fore squeezing the throttle trigger.
Do not cut material with the choke/fast idle lever at the FULL position.
For cold engine or warm engine after run- ning out of fuel.
NOTE: In the following steps, when the cho- ke/fast idle lever is pulled out to the full ex- tent, the correct throttle setting for starting is set automatically.
SPull the choke/fast idle lever out to the full extent.
SPull the starter rope quickly with your right hand until the engine attempts to start, then push the choke/fast idle lever
to the OFF position.
SPull the starter rope quickly with your
right hand until the engine starts.
SAllow the engine to run for approximate- ly five seconds. Then, squeeze and re- lease the throttle trigger to release the fast idle, allowing the engine to idle.
8
