Poulan 545123817 instruction manual Assembly, Computed kickback angle CKA Table, Loosen

Computed kickback angle (CKA) Table

	BAR				CKA without chain brake
MODEL	P/N		Length	CHAIN P/N
PP4620AVX	952044815		20″	952051310	31_
NOTE: If this saw is to be used for commer-				4443. All U.S. forest land and the states of
cial logging, a chain brake is required and				California, Idaho, Maine, Minnesota, New
shall not be removed or otherwise disabled				Jersey, Oregon, and Washington require by
to comply with Federal OSHA Regulations				law that many internal combustion engines
for Commercial Logging.				to be equipped with a spark arresting screen.
SAFETY NOTICE: Exposure to vibrations				If you operate a chain saw in a state or locale
				where such regulations exist, you are legally
through prolonged use of gasoline powered
				responsible	for maintaining	the operating
hand tools could cause blood vessel or nerve
				condition of these parts. Failure to do so is
damage in the fingers, hands, and joints of
				a violation of the law. Refer to the SERVICE
people prone to	circulation	disorders or
				section for	maintenance	of the spark
abnormal swellings. Prolonged		use	in cold
				arresting screen.
weather has been linked to blood vessel
damage in otherwise healthy people. If				Failure to follow all Safety Rules and Precau-
symptoms occur such as numbness, pain,				tions can result in serious injury. If situations
loss of strength, change in skin color or texture,				occur which are not covered in this manual,
or loss of feeling in the fingers, hands, or joints,				use care and good judgement. If you need
discontinue the use of this tool and seek				assistance, contact your authorized service
medical attention. An anti-vibration system				dealer or call 1-800--554--6723.
does not guarantee the avoidance of these				STANDARDS: This saw is listed by Under-
problems. Users who operate power tools on				writer’s Laboratories, Inc. in accordance with:
a continual and regular basis must monitor				ANSI B175.1-2000 American National
closely their physical condition and the				Standards for Gasoline--Powered Chain
condition of this tool.				Saws -- Safety Requirements
SPECIAL NOTICE: Your saw is equipped				CSA Z62.1-1995Chain Saws -- Occupa-
with a temperature limiting muffler and spark				tional Health and Safety
arresting screen which meets the				CSA Z62.3-1996Chain Saw Kickback Oc-
requirements of California Codes 4442 and				cupational Health and Safety

ASSEMBLY

Protective gloves (not provided) should be worn during assembly.

ATTACHING THE BUMPER SPIKE (If not already attached)

The bumper spike may be used as a pivot when making a cut.

1.Loosen and remove bar knob completely by lifting lever and turning counterclock- wise.

2.Remove clutch cover.

3.Attach the bumper spike with the two screws as illustrated.

1.Loosen and remove bar knob completely by lifting lever and turning counterclock- wise.

LOOSEN

2.Remove clutch cover. Remove the plas- tic shipping spacer (if present).

ATTACHING THE BAR & CHAIN (If not already attached)

WARNING: If received assembled,
repeat all steps to ensure your saw is prop-
erly assembled and all fasteners are secure.
Always wear gloves when handling the	3. Slide guide bar on bar bolts until guide
chain. The chain is sharp and can cut you
even when it is not moving!	bar stops against clutch drum sprocket.

6