OPERATING INSTRUCTIONS FOR PRUNER ATTACHMENT
OPERATING POSITION
ALWAYS WEAR:
Head
Protection Eye
Protection
Long Pants
Heavy Shoes
DANGER: Do not extend arms above shoulders while pruning. Do not stand be- neath branch being cut.
WARNING: Always wear head, eye, hearing, foot and body protection to reduce the risk of injury when operating this unit.
When operating unit, clip shoulder strap onto clamp, stand as shown and check for the fol- lowing:
SExtend your left arm and hold assist handle with your left hand.
SHold trigger handle with your right hand with finger on trigger switch.
SKeep motor end below waist level.
SKeep shoulder strap pad centered on your left shoulder and danger sign centered on
your back.
S Maintain full weight of tool on your left shoulder.
Always release the trigger switch as soon as the cut is completed, allowing the motor to stop. Keep the cord away from the cutting area. Position cord so it will not be caught on branches and the like during cutting.
PRUNING
WARNING: Be alert for and guard against kickback. Do not allow the moving chain to contact any other branches or ob- jects at the nose of the guide bar when prun- ing. Allowing such contact can result in seri- ous injury.
IMPORTANT POINTS
SWork slowly, keeping both hands firmly gripped on the pruner. Maintain secure
footing and balance.
SPlan cut carefully. Check direction branch will fall.
SWatch out for springpoles. Springpoles are small size limbs which can catch the chain and whip toward you or pull you off balance. Use extreme caution when cutting small
size limbs or slender material.
SWatch out for branches immediately behind the branch being pruned. If the chain hits
the rear branch, damage to the unit may oc- cur.
SBe alert for springback. Watch out for branches that are bent or under pressure. Avoid being struck by the branch or the pruner when the tension in the wood fi- bers is released.
SKeep a clear work area. Frequently clear branches out of the way to avoid tripping over them.
SLong branches should be removed in several pieces.
PRUNING TECHNIQUE
When ready to cut, squeeze trigger switch and allow unit to reach full speed. Apply a light cutting pressure. DO NOT use back and forth sawing action.
Second cut
Third cut
Collar 
First cut
Pruning technique
1. Make the first cut 6 inches (15 cm) from the tree trunk on the bottom of the limb. Use top of guide bar to make this cut. Cut 1/3 through the diameter of the limb.
NOTE: When making the second and third cuts, rest the foot of the pruner against the tree limb that is being cut to prevent whipping of the branch.
Foot
2.Next, move 2
3.Then, make a final cut leaving a 1
13
