ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY |
| INSERT | ||
5/16 HEX |
| |||
A socket wrench set will make assembly easier. Standard |
| |||
wrench sizes are listed. | BOLT |
| ||
|
| |||
(1) | 1/2" wrench | 5/16 LOCK |
| |
(2) | 3/4" wrench | WASHER |
| |
(3) | Pliers | LARGE FLAT |
| |
(4) | Utility knife | WASHER |
| |
|
| |||
(5) | Tire pressure gauge |
|
| |
When right or left hand is mentioned in this manual, it means |
| STEERING | ||
when you are in the operating position (seated behind the |
| |||
steering wheel). |
| WHEEL | ||
TO REMOVE TRACTOR FROM | STEERING BOOT | ADAPTER | ||
|
|
| ||
CARTON |
|
| ||
UNPACK CARTON | TABS |
| ||
• Remove all accessible loose parts and parts cartons | TAB | |||
| ||||
| from carton. |
| SLOTS | |
•Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat. | EXTENSION SHAFT |
•Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM | LOWER STEERING SHAFT |
03132 | |
SKID |
|
ATTACH STEERING WHEEL (See Fig. 1) | FIG. 1 |
ASSEMBLE EXTENSION SHAFT AND BOOT
•Slide extension shaft onto lower steering shaft.
• Place tabs of steering boot over tab slots in dash and | INSTALL SEAT (See Figs. 2 and 3) | |
push down to secure. | • Remove bolt and flat washer securing seat to cardboard | |
INSTALL STEERING WHEEL | ||
packing and set aside for assembly of seat to tractor. | ||
• Position front wheels of the tractor so they are pointing | Remove the cardboard packing and discard. | |
straight forward. | • Connect switch to seat. | |
• Remove steering wheel adapter from steering wheel | • Place seat on seat pan so all three (3) bottom pads | |
and slide adapter onto steering shaft extension. | are positioned over large slotted holes in pan. |
• Position steering wheel so cross bars are horizontal |
| |
(left to right) and slide inside boot and onto adapter. |
| |
• Assemble large flat washer, 5/16 lock washer, 5/16 hex |
| |
bolt and tighten securely. | SEAT | |
• Snap steering wheel insert into center of steering | ||
SWITCH | ||
wheel. |
| |
• Remove protective materials from tractor hood and | PAD | |
grill. | ||
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN |
| |
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO | SLOT | |
ROLL OFF SKID. | SEAT | |
| ||
| PAN | |
| TAPE | |
| WIRING HARNESS | |
| Fig. 2 |
6
