Impeller ROD Assembly, Traction ROD Assembly

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PP291EPS27 (96198002900)

HANDLES

KEY	PART	DESCRIPTION
NO.	NO.	DESCRIPTION

1	180480	IMPELLER ROD ASSEMBLY
2	405740	TRACTION ROD ASSEMBLY

8 9

3	180445	SHIFTER ROD TOP
4	187716	SHIFTER ROD BOTTOM
5	180447	SPRING SLEEVE
6	178669	IMPELLER SPRING
7	180926	TRACTION SPRING
8	72270505	CARRIAGE BOLT 5/16-18 X .75

9	155377	NUT 5/16-18
10	169675	RETAINER

01.12.001-E

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 31

Image 31

Poulan PP291EPS27 Impeller ROD Assembly, Traction ROD Assembly, Shifter ROD TOP, Shifter ROD Bottom, Spring Sleeve

Contents

Snow Thrower Model Number Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Parts Packed Separately in Carton Install Traction Drive Control ROD See Figs Install Speed Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotater Head See Fig Install Auger Control ROD See Figs Check Tire Pressure Install Chute Deflector Remote Control See Figs Ignition KEY OperationKnow Your Snow Thrower Primer Recoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow Thrower To Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Adjust Skid Plates See Fig Check Engine OIL Level See Fig Before Starting the EngineScraper BAR See Fig To USE Drift Cutters See Fig If Recoil Starter has Frozen Snow Throwing TipsTo Start Engine Before Stopping Lubrication MaintenanceGeneral Recommendations Before Each USE Engine Cleaning Shear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute Deflector To Replace Belts See Fig Engine Speed To Adjust Cable Tension See FigTo Remove Wheels See Fig Carburetor Engine OIL StorageOther Fuel System Troubleshooting Service Notes Exploded KEY Part Description Bearing Plug Auger HousingScraper BAR Auger Bearing Auger 27 RH Auger 27 LH Lockwasher 5/16 Drift Cutter BARCARRIAGEBOLT5/16−18X.750 Plastic Washer Shield Retainer Strap Knob BlackPOP Rivet Chute Snow Shield Rotator Head LEVER/CABLE Rotator AssemblyCable Assembly Adjustable Cable Assembly Heat Shield Pivot Support Loop Handle LHLoop Handle RH Lower Tube Handle Knob SpacerRetainer Knob RED Shifter ROD Bottom Impeller ROD AssemblyTraction ROD Assembly Shifter ROD TOP Flood Headlight Wire HarnessConsole Panel Headlight Bezel Repair Parts Snow Thrower - Model Number PP291EPS27 Drive Exploded Rubber Ring AssemblyDrive Plate Assembly Speed Selector Engine Mounting Plate Complete LCT EngineFrame 427963X428 Idler Pulley Impeller BeltTraction Belt Idler ARM Bracket 01.21.014-A Cover Assembly Cable Bracket RH Cable Bracket LH Clutch Slide CoverWheel Driver Retainer Ring Wheel Lobe 422663 Safety Ignition KEY DECAL, Instruction 181037DECAL, Danger DECAL, DANGER, Deflector Service Notes Limited Warranty

Poulan PP291EPS27 Impeller ROD Assembly, Traction ROD Assembly, Shifter ROD TOP, Spring Sleeve

Models: PP291EPS27 96198002900

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PP291EPS27 (96198002900)

KEY

IMPELLER ROD ASSEMBLY

TRACTION ROD ASSEMBLY

SHIFTER ROD TOP

SHIFTER ROD BOTTOM

SPRING SLEEVE

IMPELLER SPRING

TRACTION SPRING

RETAINER