Poulan PP291EPS27, 96198002900 specs

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PP291EPS27 (96198002900)

DRIVE

	7
1b	4
8	3
	3
1b
7	1a
	1a

			KEY	PART	DESCRIPTION
		2	NO.	NO.	DESCRIPTION
		2	1	404923	AXLE ASSEMBLY (assy of 1a,1b)
			1	404923	AXLE ASSEMBLY (assy of 1a,1b)
5	3		1a	404307	AXLE SHAFT
5			1b	9465M1	ROLL PIN 3/16 X 1.50
	4		1b	9465M1	ROLL PIN 3/16 X 1.50
	4		2	402691	SPROCKET
6	01.03.002-A		3	174697	THRUST WASHER
			4	179830	BEARING
			5	146315	SCREW 5/16−18 X .625
			6	17490508	SCREW 5/16−18 X .500
			7	155443	KLIK PIN 1/4 X 1.50
			8	189282	SQUARE KEY

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.

Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 33

Image 33

Poulan 96198002900 owner manual Repair Parts Snow Thrower - Model Number PP291EPS27 Drive

Contents

Snow Thrower Model Number Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents HOW to SET UP Your Snow Thrower Assembly / PRE-OPERATIONParts Packed Separately in Carton Remove Snow Thrower from Carton Install Speed Control ROD See Figs Install Traction Drive Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotater Head See Fig Install Auger Control ROD See Figs Check Tire Pressure Install Chute Deflector Remote Control See Figs Know Your Snow Thrower OperationPrimer Ignition KEY Recoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow Thrower Power Steering Operation See Fig Using the CLEAN-OUT Tool See FigTo Adjust Skid Plates See Fig To Move Forward and Backward See Fig Scraper BAR See Fig Before Starting the EngineTo USE Drift Cutters See Fig Check Engine OIL Level See Fig To Start Engine Snow Throwing TipsBefore Stopping If Recoil Starter has Frozen General Recommendations MaintenanceBefore Each USE Lubrication Engine Cleaning To Adjust Snow Thrower Height Service and AdjustmentsChute Deflector Shear Bolts See Fig To Replace Belts See Fig To Remove Wheels See Fig To Adjust Cable Tension See FigCarburetor Engine Speed Other StorageFuel System Engine OIL Troubleshooting Service Notes Exploded KEY Part Description Scraper BAR Auger HousingAuger Bearing Bearing Plug Auger 27 RH Auger 27 LH CARRIAGEBOLT5/16−18X.750 Drift Cutter BARPlastic Washer Lockwasher 5/16 POP Rivet Knob BlackChute Snow Shield Shield Retainer Strap Cable Assembly Adjustable LEVER/CABLE Rotator AssemblyCable Assembly Heat Shield Rotator Head Loop Handle RH Loop Handle LHLower Tube Pivot Support Retainer SpacerKnob RED Handle Knob Traction ROD Assembly Impeller ROD AssemblyShifter ROD TOP Shifter ROD Bottom Console Panel Wire HarnessHeadlight Bezel Flood Headlight Repair Parts Snow Thrower - Model Number PP291EPS27 Drive Exploded Drive Plate Assembly AssemblySpeed Selector Rubber Ring Frame Complete LCT Engine427963X428 Engine Mounting Plate Traction Belt Impeller BeltIdler ARM Bracket Idler Pulley 01.21.014-A Cover Assembly Cable Bracket RH Cable Bracket LH Wheel Driver Retainer Ring CoverWheel Lobe Clutch Slide 422663 Safety Ignition KEY DECAL, Danger 181037DECAL, DANGER, Deflector DECAL, Instruction Service Notes Limited Warranty

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PP291EPS27 (96198002900)

DRIVE

KEY

01.03.002-A