9 | CHUTE LATCH ASSEMBLY |
(See Fig. 9) |
Use Hardware - - GROUPS "F & G"
1.Assemble latch pin to upper chute, as shown.
2.Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.
3.Tighten all hardware securely.
| WASHERS |
#10 x | 3/16 x 3/4 x 16 Ga. |
SPLIT
SPACER
ACORN NUT
UPPER CHUTE | RUBBER |
LATCH |
WELD
#10 x 5/8" NUT SCREW
LOWER CHUTE | LOCK WASHER | |
WASHER | ||
2102 | ||
3/16 x 3/4 x 16 Ga. | ||
| 0 |
FIG. 9
10UPPER CHUTE (See Figs. 10A & 10B) No hardware required
1.Lower mower deck to its lowest cutting position.
2.Assemble upper chute by inserting curved end into hole in back of cover.
NOTE: Handle carefully so as not to damage dump bag indicator.
3.Push in and turn upper chute until it is in line with lower chute.
4.Align the bosses on lower chute with alignment slots on upper chute and slide together.
5.Secure with rubber latch by hooking hole in latch over latch pin.
| DUMP BAG | HANDLE |
UPPER | INDICATOR |
|
CHUTE |
|
|
COVER
02344
WARN | ING |
|
LOWER
CHUTE
WARN | ING |
|
FIG. 10A
ALIGNMENT
SLOTS
LATCH PIN
02 | 345 |
|
WARN | ING |
|
WARN | ING |
|
RUBBER
LATCH
BOSSES
FIG. 10B
11 LEVEL MOWER DECK No hardware required
Be sure deck is properly leveled for best mower performance. See your tractors owner's manual for instructions.
10