6 | CONTAINER ASSEMBLY (See Fig. 6) |
No hardware required |
1.Place bottom half inside of top half, as shown.
2.Place one foot inside bottom half and lift top half to meet bottom half.
3.Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT:BEFORE LOCKINGTHETABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAPTO FORM SEAL AS SHOWN IN INSET.
4. Repeat for second container.
7 CONTAINER MOUNTING (See Fig. 7)
No hardware required
1.Install one container to left side first with warning to outside of unit. Install other container to right side.
NOTE: Right container should always overlap left container at center support.
2.Close cover and lock latch handle over center support tube.
CONTAINER
BOTTOM HALF
02089
CONTAINER
TOP HALF
| 02739 | |
| PRESS TOGETHER | |
CONTAINER | TO FORM SEAL | |
WHILE LIFTING | ||
TOP HALF | ||
TOP HALF | ||
|
COVER LATCH
HANDLE
CONTAINER
WARNING
G IN RN | A W |
|
CONTAINER
HANDLE
02082
FIG. 7
CENTER
SUPPORT
TUBE
CONTAINER WARNING
CONTAINER
BOTTOM
HALF
LOCKING
TAB
FIG. 6
ASSEMBLY CHECK: Squeeze sides of lower half of con- tainer and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.
8 | LOWER CHUTE (See Fig. 8) |
Use Hardware - - GROUP "E" |
1.Raise and hold deflector shield in upright position.
2.Slide back edge of chute over rear corner of mower deck and pivot forward.
3.Align slot in lower chute with hex bolt in mower deck baffle and close chute over deck openning.
4.Secure with washer and wing nut.
CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.
DEFLECTOR SHIELD
WASHER
MOWER DECK
BAFFLE
02097
02343
WING NUT | HEX BOLT |
|
9 | FIG. 8 |
|
