•The average lawn should be cut to ap- proximately
•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. NOTE: Be sure tractor is on a flat level surface.
1.Lower mower and adjust mower to de- sired cutting height(See “TO ADJUST MOWER CUTTING HEIGHT” in this section of manual).
2.Remove retainer spring and clevis pin which secure each gauge wheel bar.
3.Lower gauge wheels to ground. Raise gauge wheels slightly to align holes in bracket and gauge wheel bar and insert clevis pin. Gauge wheels should be slightly off the ground.
4.Replace retainer spring into clevis pin.
5.Be sure all gauge wheels are in the same setting.
IMPORTANT: Be sure to readjust gauge wheels if you change the cutting height of the mower deck.
Retainer
Spring
019 | 77 |
|
Clevis
Pin
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equip- ment on rough, rolling terrain or hills.
1.Select desired height of cut.
2.Start mower blades by engaging at-
tachment clutch control.
TO STOP MOWER BLADES - disengage attachment clutch control.
CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.
Attachment | Attachemnt Lift Lever | |
Clutch Lever | ||
High Position | ||
“Engaged” | ||
| ||
Position |
|
Low
Position
“Disengaged” Position
02661 | Deflector |
Shield
TO OPERATE ON HILLS
WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope. Use the slope guide provided at the back of this manual.
•Choose the slowest speed before start- ing up or down hills.
•Avoid stopping or changing speed on hills.
•If slowing is necessary, move throttle control lever to slower position.
•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake posi- tion and engage parking brake.
•Move motion control lever to neutral (N) position.
IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is depressed.
16
