Poulan CO24H48STA manual Service and Adjustments, To Remove Mower, To Install Mower

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

1.Depress clutch/brake pedal fully and set parking brake.

2.Place motion control lever in neutral (N) position.

3.Place attachment clutch in “DISENGAGED” position.

4.Turn ignition key to “STOP” and remove key.

5.Make sure the blades and all moving parts have completely stopped.

6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER

1.Place attachment clutch in “DISEN- GAGED” position.

2.If equipped, turn height adjustment knob to lowest setting.

3.Lower mower to its lowest position.

4.Disengage belt tension rod from lock bracket.

CAUTION: Rod is spring loaded. Have a tight grip on rod and release slowly.

5.Remove retainer spring holding anti-swaybar to chassis bracket and disengage anti-sway bar from bracket.

6.Remove four retainer springs from front plate assembly and remove plate.

7.Remove retainer springs from suspen- sion arms at deck and disengage arms from deck.

8.Raise attachment lift to its highest position.

9.Slide mower forward and remove belt from electric clutch pulley.

10.Slide mower out from under right side

of tractor.

Lock Bracket

TO INSTALL MOWER

Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage parking brake.

1.Swing anti-sway bar to left side of mower deck.

2.Slide mower under tractor with deflec- tor shield to right side of tractor.

IMPORTANT: Check belt for proper rout- ing in all mower pulley grooves.

3.If equipped, turn height adjustment knob counterclockwise until it stops.

4.Lower mower linkage with attachment lift control.

5.Be sure belt tension rod is in disen- gaged position.

6.Install belt into electric clutch pulley groove.

7.Place the suspension arms on outward pointing deck pins. Retain with double loop retainer spring with loops up as shown.

8.Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown.

Belt Tension Rod (Disengaged Position)

Chassis

Bracket

Retainer

Spring

Anti-Sway

Bar

USE PLIERS FOR

RETAINER SPRINGS

Loop Up

Front Mower	Electric Clutch	Double Loop
Bracket	Pulley
		Retainer Springs
		Front Plate
		Assembly
		Single Loop
		Retainer Springs
		Flanged Pins
		Front Mower
		Bracket
Suspension Arms
Double Loop
Retainer Springs
(Outward pointing
deck pins)	02565	Deflector Shield

24