ASSEMBLY
1 | BAGGER SUPPORT ASSEMBLY |
| (See Fig. 1) |
1.Slide fl anges of support assembly into drawbar slots first, then, pivot backwards inserting pin into drawbar pin hole.
2.Be sure support assembly is seated properly, then secure with retainer spring.
SUPPORT
ASSEMBLY
DRAWBAR SLOTS
INSERT
FLANGES
FIRST INTO
DRAWBAR
SLOTS
|
| 02543 | PIN |
|
|
| |
| DRAWBAR |
|
|
| PIN HOLE | FIG. 1 | RETAINER |
2 |
|
| SPRING |
MOUNTING COVER ASSEMBLY TO | |||
SUPPORT ASSEMBLY (See Fig. 2) | |||
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting coverassembly to tractor.
1.Position cover assembly on ground behind tractor.
2.Lift and rotate cover to align cover brackets with support assembly tubes.
3.Slide cover assembly down onto the support tubes.
SUPPORT
ASSEMBLY
COVER
ASSEMBLY
03024 |
3 CONTAINER ASSEMBLY (See Fig. 3)
1.Place bottom half inside of top half, as shown.
2.Place one foot inside bottom half and lift top half to meet bottom half.
3.Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT:BEFORE LOCKINGTHETABS, HOOKED EDGES ONBOTHHALVESMUSTOVERLAPTOFORMSEALASSHOWN IN INSET.
4. Repeat for other containers.
CONTAINER
BOTTOM HALF
02089
CONTAINER
TOP HALF
| 39 | |
| 027 | |
| PRESS TOGETHER | |
CONTAINER | TO FORM SEAL | |
WHILE LIFTING | ||
TOP HALF | ||
TOP HALF | ||
|
CONTAINER
BOTTOM
HALF
LOCKING
TAB
FIG. 3
ASSEMBLY CHECK: Squeeze sides of lower half of con- tainer and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.
02097
FIG. 2 | 5 |
