3 ASSEMBLE CONTAINERS (See Fig. 3)
•Place bottom half inside of top half, as shown.
•Place one foot inside and lift top half.
•Press halves tightly together while lifting top to lock into place.
IMPORTANT: Before locking the tabs, hooked edges on both halves must overlap to form seal all the way around the container - see inset.
CONTAINER
BOTTOM HALF 
CONTAINER ASSEMBLY CHECK: Squeeze sides of lower half to see if there are any gaps between upper and lower halves. If a gap appears, unlock tabs, separate halves and repeat assembly.
WAR | NING |
|
02097
39 027
CONTAINER
TOP HALF
02089
CONTAINER
TOP HALF
PRESS TOGETHER TO FORM SEAL WHILE LIFTING TOP HALF
4 MOUNT CONTAINERS (See Fig. 4)
•Install one container to left side fi rst with warning to outside of unit. Center container next, then right side.
NOTE: Right container should always overlap left container at center supports.
•Close cover and lock latch handles over center support tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
|
|
| 3 |
|
| 8 | |
| 0 |
| |
2 |
|
| |
0 |
|
|
|
WARnottotoNIpewrdNGaeatamer amagnoedwdde. erUstuienerileoosrnaslytcioaonnr.etaCcihnoemecrmkisenbpardgoepfrdeerrqleyupiselacnntsleytma. lReelendtp.cClaoocnnettaawinihneeernr. is Dobjecd or csruacke
CONTAINER BOTTOM HALF
ntaihneernis stalledp.Colacnetawiner. WARnottotoNIpewrdNGaeatamer amagnoedwdde. erUstuienerlieoosrnaslytcioaonnr.etaChcinoeemcrmkisebpnardgoepfrdeerrqleyupiselannctleym. Reent co 
csDoruabcjekecd or
LOCKING | CENTER |
TAB | |
| SUPPORT |
| TUBES |
| CONTAINER |
| HANDLE |
| CONTAINER |
| WARNING |
| FIG. 4 |
FIG. 3 | 3 |
|
