SERVICE
WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments.
We recommend all service and adjustments not listed in this manual be performed by an authorized service dealer.
MAINTENANCE SCHEDULE
Check:
Fuel mixture level . . . . Before each use Bar lubrication . . . . . . . Before each use Chain tension . . . . . . . Before each use Chain sharpness . . . . Before each use For damaged parts . . Before each use For loose caps . . . . . . Before each use For loose fasteners . . . Before each use For loose parts . . . . . . Before each use
Inspect and Clean:
Bar . . . . . . . . . . . . . . . . Before each use Complete saw . . . . . . . After each use Air filter . . . . . . . . . . . . . Every 5 hours* Chain brake . . . . . . . . Every 5 hours* Spark arresting screen
and muffler . . . . . . . . . Every 25 hours* Replace spark plug . Yearly Replace fuel filter . . . Yearly
* Hours of Operation
AIR FILTER
CAUTION: Do not clean filter in gasoline
or other flammable solvent to avoid creating a fire hazard or producing harmful evapora- tive emissions.
Cleaning the air filter:
A dirty air filter decreases engine perform- ance and increases fuel consumption and harmful emissions. Always clean after 15 tanks of fuel or 5 hours of operation, which- ever comes first. Clean more frequently in dusty conditions. A used aire filter can never be completely cleaned. It is advisable to re- place your air filter with a new one after every 50 hours of operation, or annually, whichever comes first.
1.Loosen 3 screws on cylinder cover.
2.Remove cylinder cover.
3.Remove air filter.
4.Clean the air filter using hot soapy water. Rinse with clean cool water. Air dry com- pletely before reinstalling.
5.Reinstall air filter.
6.Reinstall cylinder cover and 3 screws. TIghten securely.
Air Filter
Air Filter
Screws
INSPECT MUFFLER AND SPARK ARRESTING SCREEN
As the unit is used, carbon deposits build up on the muffler and spark arresting screen, and must be removed to avoid creating a fire hazard or affecting engine performance.
Replace the spark arresting screen if breaks occur.
CLEANING THE SPARK
ARRESTING SCREEN
Clean every 25 hours of operation or annually, whichever comes first.
Steel
Backplate
Muffler
Muffler
Bolts
Aluminum
Backplate Muffler
GasketBolt Cover Locknut
1.Loosen and remove the 3 cylinder cover screws. Remove the cylinder cover.
2.Pull off the spark plug boot.
3.Loosen and remove the locknut from the bolt cover. Remove the bolt cover.
4.Loosen and remove the 2 muffler bolts. Remove the muffler and backplates. No- tice the orientation of these parts for re- assembling.
5.Locate the 2 outlet cover screws on the muffler. Loosen and remove both screws. Remove the outlet cover and spark arresting screen.
BACK VIEW OF MUFFLER
Outlet Cover | Muffler |
|
Screws
Spark Arresting
Screen
6.Clean the spark arresting screen with a wire brush. Replace screen if any wires are broken or screen is blocked after cleaning.
7.Reinstall spark arresting screen.
8.Reinstall outlet cover and 2 screws. En- sure outlet cover and both screws are re- installed correctly to prevent damage to the saw (see illustrations). The exhaust outlets must face the chain brake (bar side) of the saw.
14
