E.CLEANING THE FRYER
CLEANING THE KETTLE: HOT BOIL-OUT METHOD
SLIPPING & FALLING HAZARD / SPILLED OIL
DO NOT STORE OIL IN THE FILTER RESERVOIR WHILE
CLEANING THE KETTLE. IF CLEANING FLUID IS ACCIDENTALLY
DRAINED INTO THE FILTER RESERVOIR, OIL WILL SPILL ON THE
FLOOR.
Death or serious injury may result from falls caused by slipping in oil
NOTE: Use a
1.Slide the LID AND YOKE to the rear. Press the POWER SWITCH to the OFF position.
2.Discard old oil as detailed in section D, page 14.
3.Fill the with 4 gallons of cold water.
4.Press the POWER SWITCH to the FRYER position.
5.Allow the water to come to a full boil, then press the POWER SWITCH to OFF. When the boiling ceases, slowly add, and
CAUTION:
BURN HAZARD / HOT WATER SPLATTER
TURN THERMOSTAT TO LOWEST TEMPERATURE SETTING
(FULLY COUNTERCLOCKWISE).
USE ONLY
CAREFULLY FOLLOW CLEANSER INSTRUCTIONS AND WARNINGS. DO NOT LEAVE FRYER UNATTENDED WHILE BOILING OUT THE KETTLE.
WHEN WATER FOAMING OCCURS, BE PREPARED TO TURN THE POWER SWITCH “OFF”.
Boiling water will splatter and could result in serious injury.
5.Press the POWER SWITCH to FRYER. When the water begins to boil, press it to OFF . When the boiling subsides, again press the POWER SWITCH to FRYER. Repeat this procedure (i.e.
6.With the POWER SWITCH OFF, allow the hot solution to set for thirty (30) minutes.
15