Hitachi CP-S845W Do not place this unit where it gets hot, Volume, Cleaning the lens

Caution

Caution when replacing the lamp.

•When replacing the lamp, turn off the power of

the projector and disconnect the power plug from the power outlet. Then wait for

45 minutes to allow the lamp cool: Failure to do so could result in a burn.

• For disposal of used lamp, treat
according to the instruction of	Pull out the
	power plug
community authorities.
	from the
• Since the lamp is made of glass, do
	power
not apply shock to it and do not	outlet.
scratch it.

• Also, do not use old lamp. This could also cause
explosion of the lamp.
• If it is probable that the lamp has exploded
(explosive sound is heard), disconnect the power
plug from the power outlet and ask your dealer
to replace lamp.
• In rare cases, the reflector and the inside of the
projector may be damaged by scattered broken
pieces of glass, and broken pieces could cause	Front glass
injury when being handled.
• When the lamp has been replaced, reset the	Reflector
accumulated operation time of the lamp.	Lamp
• Do not reset if the lamp has not been replaced.

ENGLISH

[General cautions]

Do not place this unit where it gets hot.

Be careful since if you place the unit outdoors, in a place exposed to direct sunlight or near a heating device, the cabinet and parts could be affected.

Volume.

Use at the proper volume level so that it does not bother persons in the neighborhood. Especially, since the sound is likely to carry well at the night even at a low volume, consider the neighborhood to a good living environment.

Cleaning the lens.

To clean the lens, use a generally-available lens cleaning tissue (used for cleaning lens of camera, glasses, etc.). Be careful not to scratch the lens with a hard object.

Cleaning the cabinet.

•Since many plastic materials are used on the surface of the cabinet, if the surface is cleaned using benzene, thinner, etc., it may change in quality or the coating may be peeled off. Avoid using chemicals.

•When a chemically-teated cloth is used, follow the cautions that come with the cloth.

•Do not spray a volatile agent such as insecticide on the unit. Do not leave a rubber or vinyl object touching the cabinet for a long time. It may cause the cabinet to change in quality or the coating to peel off.

•Clean the dirt from the cabinet and operation panel by dusting lightly with a soft cloth. If the dirt is conspicuous, wipe off with a cloth moistened with detergent diluted with water, then wipe off with a dry soft cloth.

Rest your eyes occasionally when viewing for a long time.

7