Scag Power Equipment STT61V-35BVAC, STT-29DFI, STT61V-29DFI, STT-35BVAC Engine Air Cleaner, Section

Models: STT-35BVAC STT61V-29DFI-LE STT61V-35BVAC STT61V-29DFI STT-29DFI

1 95
Download 95 pages 22.66 Kb
Page 42
Image 42
B. Replacing In-Line Fuel Filter Elements

R

Section 7

FILLER NECK

INSERT

1/2.

1/4. 7.6 Engine Air Cleaner .3/4 E.A. Cleaning and/or Replacing Air Cleaner Element .F

FUEL LEVEL

Figure 7-6. C.A.R.B. / EPA Phase 3 Fuel Level

To avoid personal injury or property damage, use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive.

1.Extinguish all cigarettes, cigars, pipes and other sources of ignition.

2.Use only an approved gasoline container.

3.Never remove the gas cap or add fuel with the engine running. Allow the engine to completely cool before fueling.

4.Never fuel the machine indoors or in an enclosed trailer.

5.Never store the machine or fuel container where there is an open flame, spark or pilot light such as on a water heater or other appliances.

6.Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground away from your vehicle before filling.

7.Remove the machine from the truck or trailer and fuel on the ground. If this is not possible, then refuel the machine with a portable container, rather than from a gasoline dispenser nozzle.

8.Keep the nozzle in contact with the rim of fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device.

9.If fuel is spilled on clothing, change clothing immediately and wash affected skin.

10.Replace gas cap and tighten securely. For Low Emission (LE) and EPA Phase 3 (produced after 1/1/2011) models, tighten the fuel cap until it ratchets.

B. Replacing In-Line Fuel Filter Elements

The engine fuel filter should be replaced after every 500 hours of operation or annually, whichever occurs first. See Figure 7-6.

1.Close the shut-off valve.

2.Remove the two clamps securing the fuel filter to the fuel hose. Remove the fuel filter.

3.Install a new fuel filter. Be sure it is installed in the proper direction. Secure to the fuel hose using the two clamps.

4.Open the fuel shut-off valve.

Fuel Filter

(with hose clamps above and below)

STT99FF-1

Figure 7-7. Fuel Filter

7.6 Engine Air Cleaner

A. Cleaning and/or Replacing Air Cleaner Element

For any air cleaner, the operating environment dictates the air cleaner service periods. Inspect and clean the air cleaner element after every 100 hours of operation or bi-weekly, whichever occurs first and replace the element if required. See Engine Owner's Manual for service information.

36

Page 42
Image 42
Scag Power Equipment STT61V-35BVAC, STT-29DFI manual Engine Air Cleaner, Section, B. Replacing In-Line Fuel Filter Elements