OPERATING THE COUPLER
Your powerhead is equipped with a coupler which enables optional attachments to be installed. The optional attachments are:
MODEL:
Edger . . . . . . . . . . . . . . . . . . . . . . PPB1000E Blower . . . . . . . . . . . . . . . . . . . . . PPB3000B Brushcutter . . . . . . . . . . . . . . . . PPB4000C
WARNING: Always disconnect pow- erhead spark plug (or disconnect powerhead from powersource) beforeremoving or instal- ling attachments.
REMOVING ATTACHMENT
CAUTION: When removing or installing at- tachments, place the powerhead and attach- ment on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Upper Shaft
Coupler
INSTALLING ATTACHMENT HANGER
An attachment hanger is provided for storage when attachment is not in use.
To install hanger on attachment:
1.Remove the shaft cap from the attachment (if present) and discard.
2.Press and hold the locking/release button.
3.Push hanger onto the attachment until the locking/release button snaps into the hole.
OPERATING POSITION
ALWAYS WEAR:
Eye Protection
Long Pants
Heavy Shoes
Lower
LOOSEN
Attachment
TIGHTEN Knob
2. Press and hold the locking/release button.
Locking/Release Button
Coupler | Upper Shaft | |
Lower Attachment | ||
|
3.While securely holding the upper shaft, pull the attachment straight out of the cou- pler.
INSTALLING ATTACHMENT
1.Remove the shaft cap from the attachment (if present) and discard.
2.Position locking/release button of attach- ment into guide recess of upper shaft cou- pler.
Coupler Primary Hole
Guide Recess
Upper Locking/ Attachment
Shaft Release
Button
3.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the knob se- curely by turning clockwise.
WARNING: To avoid personal injury, never carry the cultivator while the unit is run- ning.
WARNING: The gearbox gets very hot after extended periods of use. To avoid burns, do not touch the gearbox until it has been allowed to cool.
CULTIVATING
1.Move the cultivator to the work area prior to starting the engine/motor.
2.With the engine/motor running and the tines off the ground, press the throttle trig- ger to increase the engine speed.
3.Hold trigger handle and assist handle firm- ly. Slowly lower the cultivator until the tines make contact with the ground.
4.As unit begins cultivating, pull back on the unit so that the tines can penetrate the ground.
5
