Lock Arm Installation
(Continued)
Once track radius has been determined, secure the lock arm to the motor with
(1) 5mm x .8mm phillips pan head screw.
NOTE: If unsure of track radius, begin with lock arm in position 1.
After assembly of the lock arm, manually raise and lower the door and verify that the lock arm does not interfere with the door. If there is interference between the door and the lock arm, see Page 42 for lock arm troubleshooting.
NOTE: Do not operate the door or opener if there is interference between the lock arm and the door.
Reconnect the door to the motor operated position. Activate a motor operated up/down cycle to confirm clearance.
Lock Arm
Motor
5mm x 8mm
Phillips
Pan Screw
28 | Contact Obstruction Test | |
| ||
|
| |
Tools Needed: | After installing the opener, the door must | |
2 x 4 Board | reverse when it contacts a | |
object (or a 2 x 4 board laid flat) on the | ||
| ||
| garage floor. | |
| Using the wall station, activate the door | |
| to the fully open position. | |
| Place a 2 x 4 board flat on the garage | |
| floor, under the door path. | |
| Activate the door to the closed position | |
| with the wall station. Upon contacting the | |
| 2 x 4 board, the door should stop, then | |
| reverse direction within two seconds and | |
| travel to the full open position. | |
| If the door does not respond to the | |
| required tests, repeat profile routine Step | |
| 24 or 25, making sure the door is in the | |
| fully closed position prior to activation. | |
|
|
Center Of Door
2 x 4 Laid Flat
On Floor
WARNING
IF OPENER DOES NOT RESPOND PROPERLY TO THESE TESTS (STEPS
28 AND 29), DO NOT USE DOOR UNTIL A QUALIFIED SERVICE PERSON HAS MADE NECESSARY ADJUSTMENTS/REPAIRS, OR SEVERE OR FATAL INJURY COULD RESULT FROM OPERATING THE DOOR/OPENER.
31Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at
