20 | Sensor Wire Installation | |
(Required on all 8000 Series and | ||
other Non Pinch Resistant Doors) | ||
Tools Needed: | Uncoil wires from photoelectric sensors and route | |
wires up garage wall and along door header | ||
| ||
3/32” (2.5mm) | towards the right side of the opener. | |
Max. Flat Tip | Route wires behind torque tube and tack wires in | |
Screwdriver | ||
Pliers/Wire | place with insulated staples (not supplied). Take | |
care to run wires in a location where they will not | ||
Cutters | ||
interfere with the operation of the door. | ||
| ||
| Do Not Staple Through Wire. | |
| NOTE: If wires must be lengthened or spliced | |
| use wire nuts or suitable connectors. | |
| NOTE: Take care to run wires in a location where | |
| they will not interfere with the operation of the | |
| door and do not staple through wire. | |
| Connect photoelectric sensors to the opener | |
| terminal block on right side of the opener. Sepa- | |
| rate wire ends and strip about 1/2” of insulation | |
| off each of the wire ends. | |
| Insert a 3/32” (2.5mm) max. width fl atblade | |
| screwdriver into the lower hole #1 of the | |
| terminal block. Twist screwdriver to open wire | |
| clamp in upper hole #1 of terminal block. Insert | |
| both sender and receiver solid white wires into | |
| upper hole #1 until the wires bottom out and | |
| release screwdriver tension. Insert and twist | |
| screwdriver in lower hole #2 and insert both | |
| sender and receiver wires (white with black | |
| stripe) into upper hole #2 until wires bottom | |
| out and release screwdriver tension. Be sure to | |
| observe polarity. | |
| Once wires are connected, install jumper | |
| through the front opener cover on to the pins | |
| labeled PE. | |
| IMPORTANT! KEEP SENDER/RECEIVER WIRES | |
| AWAY FROM MOVING COMPONENTS. | |
| Lightly pull on external wires to test for secure | |
| connection. Check that the wires are stapled in | |
| place and staples have not cut wire | |
| insulation. | |
|
|
| Wire Routing |
| Insert wires |
Insert wires | into upper |
into upper | hole #2 |
hole #1 |
|
| White wires with |
Insert screw | black stripe |
| |
driver into | Insert screw |
lower hole #1 | driver into lower |
| hole #2 |
| Solid white wires |
Jumper | RIGHT HAND SIDE VIEW OF OPENER |
installed | |
| Pins labeled |
| “PE” |
| Jumper |
VIEW OF THE OPENER FROM THE FRONT | |
PRE-OPERATION
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need. 26 You can reach us Toll Free at
