TorqueMaster® Plus Installation
2 | Cable Drums | |
| ||
Tools Needed: | NOTE: If you have a Torquemaster® | |
Tape Measure | counterbalance, skip this step and continue | |
with Step 2 on page 10. If you have a | ||
| ||
Step Ladder | Torquemaster® Plus counterbalance system, | |
complete Steps | ||
| ||
| IMPORTANT! RIGHT AND LEFT HAND IS | |
| ALWAYS DETERMINED FROM INSIDE THE | |
| GARAGE LOOKING OUT. | |
| Shake the TorqueMaster® spring tube | |
| assembly gently to extend the winding shafts | |
| out about 5" on each side. For single spring | |
| applications, there will be no left hand spring | |
| in the TorqueMaster® spring tube assembly. | |
| Lift the TorqueMaster® spring tube assembly | |
| and rest it on the top of the flagangles. | |
| NOTE: Cable drums are marked right and | |
| left hand. Cable drums and TorqueMaster® | |
| spring tube assembly are cam shaped to fit | |
| together only one way. | |
| ||
| drum with the counter balance cable | |
| wraps (see illustrations). | |
| To install the cable drum, slide the correct | |
| cable drum over the winding shaft until the |
Drums come with drum wraps
on them.
TorqueMaster® Spring Tube |
|
|
|
| Right Drum | Counterbalance Cable | ||||||||||||
Assembly (Cam Peak Straight Up) |
|
|
|
|
| |||||||||||||
|
|
|
|
|
|
|
| |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5”
(Right hand cable drum shown, left hand cable drum is
symmetrically opposite)
TORQUEMASTER® INSTALLATION
cable drum seats against the TorqueMaster® |
spring tube assembly. |
The winding shaft must extend past the |
cable drum far enough to expose the splines |
and the groove. Align the winding shaft |
groove with the round notch in the flagangle. |
For double spring applications, repeat for |
opposite side. |
For single spring applications, insert |
the loose winding shaft into the left hand |
cable drum prior to sliding the cable drum |
over the TorqueMaster® spring tube |
assembly. |
Cam Peak
Straight Up
Groove
Round Notch
Flagangle
Splines
Winding Shaft
Cable
Drum
IDRIVE® FOR
NOTE: On single spring applications, take |
care in handling the loose winding shaft (left |
side) so that it does not slide back into the |
TorqueMaster® spring tube assembly. |
Cam Peak
Straight Up
Cable Drum
Groove
Counterbalance Cable
Winding Shaft
Splines
Loose Winding Shaft
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need. 8 You can reach us Toll Free at
