Wayne-Dalton 3663-372 Programming Light Fixture, Profile Routine Standard Upper Limit

23	Programming Light Fixture
Tools Needed:	Press the red program button on the light
Step Ladder	fixture. The LED on the light fixture will turn
	on and remain on for 30 seconds
	or until a opener is learned to the light
	fixture. The incandescent lamp will also turn
	on when program button is pushed.
	Press the light button on the wall station.
	This must be done within 30 seconds of
	pressing the program button on the light
	fixture. The light fixture lamp and LED will
	blink three times to indicate successful
	programming. The light fixture can now be
	turned on and off from this wall station.
	NOTE: In order to program the opener to
	the light fixture, the installer must have the
	wall station already programmed to the
	opener.

Program Button LED

Light Button

per
O	at
o	e
T	D
Press
	o
	o
	Here	r

24

Tools Needed:

None

Profile Routine

(Standard Upper Limit)

WARNING

TO AVOID INJURY, NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR!

The profile routine automatically sets the door open and close limits and calibrates obstruction sensing. During the profile routine, the door will move up and down twice.

NOTE: If an object such as a ceiling beam obstructs the door from opening completely, skip this step. Set a Custom Upper Limit, see Step 25.

NOTE: The door must be in its fully closed position and the disconnect handle must be in the motor operated position (upper position) to initiate the profile routine.

NOTE: Profile routine will not run if safety sensors are not aligned (only if required installation).

Press and hold the profile button for five (5) seconds. The opener will beep twice, release the profile button, indicating the activation of the profile routine. The door will now move to the fully open position and stop, beep twice and then the door will close completely.

Next, the door will go through one more up/ down cycle. Once this is complete, the door limits are set and the profile is complete.

NOTE: Upon successful completion proceed to Step 26.

Profile Button

PRE-OPERATION

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need. 28 You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com