Wayne-Dalton 3663-372 Profile Routine, Adjusting Detent, Custom Upper Limit, Work Properly

25		Profile Routine
		(Custom Upper Limit)
Tools Needed:		WARNING
None	TO AVOID INJURY, NO ONE SHOULD
	CROSS THE PATH OF A MOVING DOOR!

NOTE: If no obstruction interferes with a standard upper limit, skip this step.

NOTE: The door must be in its fully closed position and the disconnect handle must be in the motor operated position (upper position) to initiate the profile routine.

NOTE: Install profile will not run if safety sensors are not aligned (Only if required for your door).

Press and hold the profile button for five (5) seconds. The opener will beep twice, release the profile button, indicating the activation of the profile routine.

When the door moves to the desired upper	Up/Down
limit, press and hold the Up/Down button on	Button
the wall station until the door stops. Next,
the door will close completely. The Up/Down
button (when door is closed) can be	Profile
activated by pressing center of flip cover.
	Button

Next, the door will go through one more Up/ Down cycle. Once this is complete, the door limits are set and the profile is complete.

	Alternately, once an profile routine has been
	successfully completed, disconnect door
	and manually move to desired upper limit.
	Re-connect door and press and hold the
	profile button for five (5) seconds. The
	door will close, open and close to complete
	the profile routine with the new custom
	upper limit.
	NOTE: For a more precise location of the
	custom upper limit, see “Customizing the
	Settings” on page 37-38.
26	Adjusting Detent	Detent Pin
		Adjustment Screw
Tools Needed:	The amount of pressure the opener
	uses to pivot the motor downward is
Flat Tip	preset at the factory via the detent pin
Screwdriver	adjustment screw.
Step Ladder	Due to variations in door installations,
	a detent pin adjustment may need to
	be made in order to insure proper pivoting
	of the motor.
	IMPORTANT! FOR SYSTEM SECURITY:
	THE MOTOR IS DESIGNED TO PIVOT DOWN
	AFTER THE DOOR CLOSES COMPLETELY. IF
	THE MOTOR DOES NOT PIVOT OR PIVOTS
	TOO SOON, THE DETENT PIN ADJUSTMENT
	SCREW MAY NEED TO BE ADJUSTED IN
	ORDER FOR THE DOOR LOCK FEATURE TO
	WORK PROPERLY.

29Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com