Wayne-Dalton 3663-372 Securing the Opener, Safety Sensor Alignment, and Checking for Obstructions

21 Safety Sensor Alignment

	Top View
In	In

Tools Needed:

Pliers

Align the safety sensors by moving the sending and receiving units in or out until the alignment light on the receiving unit comes on. The 1/4”-20 carriage bolt can be loosened to move the safety sensor in or out, as required. If you have difficulty aligning the beams, check that both mounting brackets are mounted at the same height and remount if necessary. Additional minor adjustments can be made by slightly bending the mounting brackets.

Once the alignment light comes on, tighten all bolts and mounting screws. Finish securing all wires making sure not to break or open any of the conductors. Loop and secure any excess wire.

Out	Out
	1/4”-20 Carriage
	Bolts
	For this adjustment, bend
	Bracket at wall mount
	Top View

22	Securing the Opener
	and Checking for Obstructions

Tools Needed:

7/16” Wrench

Step Ladder

With the emergency disconnect still in the manual door operated position, manually raise the door to the fully open position. Then, manually lower the door to the fully closed position verifying freedom of movement and good door balance.

Tighten both 1/4”-20 flange nuts, securing the opener to the support bracket.

NOTE: Good door balance and freedom of movement are essential for proper opener performance. If door is heavy to lift, hard to close or if door sticks or binds in

the track, make proper adjustments now.

Support	1/4” - 20
Bracket	Flange Nuts

27Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com