HOW TO OPERATE THE MACHINE
How To Operate the Squeegee (“S Class” models only)
The squeegee wipes the floor while the vacuum motor removes the dirty solution from the floor. Use your right hand to lower or raise the squeegee handle. To operate the squeegee, follow this procedure:
1.To lower the squeegee and start the vac motor move the squeegee lever to the right and down. See figure #12.
2.To raise the squeegee, lift the squeegee lever up. See figure #13.
Note: The center position lets the vac motor continue to run with the squeegee off the floor to avoid drips.
How to Fill The Solution Tank
CAUTION!
Make sure water or solution does not enter the opening for the vacuum motor See figure #14.
The solution tank can be filled in the front or through the clear drain hose at the rear of the machine. To fill the solution tank follow this procedure:
1.Remove the solution tank lid. See figure #15.
2.Fill the solution tank with water.
3.Add a cleaning chemical to the water. for the correct amount, follow the directions shown on the container.
WARNING!
Water solutions or cleaning materials used with this type of machine can leave wet areas on the floor surface. These areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning.
WARNING!
Machines can ignite flammable materials and vapors. Do not use with or near flammables such as gasoline, grain dust, solvents, and thinners. Only use a cleaning concentration recommended by the chemical manufacturer.
WARNING!
Nilfisk Alto recommends a maximum water temperature of 120°F(49°C)
4.Replace the solution tank lid.
5.When filling the machine from the rear, position the clear drain hose against bracket and insert hose as shown in figure 16. Solution level can be viewed from the back of the machine.
Figure #12 | Figure #13 |
|
|
|
|
Figure #14
Figure #15
Figure #16
Nilfisk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795 | FORM NO. 70935A - 21 - |
