OPERATION

FIG. 11

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

•The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emp- tied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 7)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

14

Page 13 Page 15
Page 14
Image 14
Poulan PR25PH48STC Before Starting the Engine, Towing Carts and Other ATTACH- Ments, Check Engine OIL Level, ADD Gasoline
Page 13 Page 15

PR25PH48STC specifications

The Poulan PR25PH48STC is a versatile and powerful tool designed to handle a variety of outdoor tasks with ease. Equipped with a robust 25cc, 2-cycle engine, this string trimmer provides ample power for tackling tough weeds, grass, and even small bushes in your yard. The engine is designed to efficiently blend fuel and air, maximizing performance while minimizing emissions, making it an efficient option for eco-conscious users.

One of the standout features of the PR25PH48STC is its innovative SureFire starting system. This technology simplifies the starting process, allowing users to start the engine with minimal effort. This feature is particularly beneficial for those who may struggle with traditional starting mechanisms, ensuring that the trimmer is ready for use when you need it most.

The trimmer boasts a 48-inch straight shaft, making it easier to reach under bushes and tight spots without straining your back. The length of the shaft also provides greater control and precision, enabling users to tackle various jobs, from edging to trimming. The PR25PH48STC comes with a 0.080-inch dual line cutting head, designed to provide a clean cut with every pass. This trimmer head offers quick line replacement, an essential feature for those who frequently use their trimmer.

Comfort is a priority in the design of the Poulan PR25PH48STC, which is evident in its ergonomic handle. With a cushioned grip, users can operate the trimmer for extended periods without discomfort. The well-balanced design further enhances maneuverability, allowing for easy adjustments while trimming around landscaping features.

In terms of durability, the PR25PH48STC is built with high-quality materials that can withstand the rigors of outdoor use. Its robust construction ensures that it can handle demanding jobs without compromising performance. Moreover, the trimmer is lightweight, making it easy to transport and maneuver without fatigue.

Overall, the Poulan PR25PH48STC represents an ideal choice for homeowners and garden enthusiasts seeking a reliable and efficient string trimmer. With its powerful engine, user-friendly features, and ergonomic design, this trimmer promises to make yard maintenance a more manageable and enjoyable task. Whether you're maintaining your lawn or tackling overgrown areas, the PR25PH48STC proves itself to be an essential gardening tool.
Top Page Image Contents