OPERATION
SPARK
PLUG
SAFETY
IGNITION KEY
CHOKE
CON-
TROL
THROTTLE
/ENGINE
CONTROL
RECOIL
STARTER
ENGINE OIL CAP | AUGER | DRIVE | DISCHARGE | TRACTION |
WITH DIPSTICK | CONTROL | SPEED | CHUTE | DRIVE |
| LEVER | CONTROL | CONTROL | CONTROL |
|
| LEVER | LEVER | LEVER |
GASOLINE
FILLER
CAP
CHUTE
DEFLECTOR
OIL
DRAIN
PLUG
DISCHARGE
CHUTE
HANDLE PRIMER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT.
AUGERS
FUEL
VALVE OUT TOOL
FIG. 8
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil starter handle - used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
8
