MULCHER PLUG TYPE “B”
To convert to bagging or discharging:
SERVICE AND ADJUSTMENTS
• Lift discharge guard and remove mulcher plug.
• Mower can now be used for side dis- charging or optional grass catcher can be attached.
•To return to mulching operation, simply reinstall mulcher plug as shown, making sure tab is seated properly.
CAUTION: Do not run your lawn mower | Slots | |
without discharge guard, approved grass | ||
| ||
catcher or mulcher plug in place. |
|
CAUTION: Before performing any ser- vice or adjustments:
•Release operator presence control bar.
•Make sure the blade and all moving parts have completely stopped.
•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
LAWN MOWER
TURN LOWER
Lift discharge 
guard
| Mulcher |
SIDE DISCHARGING | plate tabs |
•Mulcher plate must be installed into rear discharge opening of mower (see above instructions).
•Open mulcher door and install discharge deflector under door as shown.
•Mower is now ready for discharging operation.
•To convert to mulching or bagging operation, discharge deflector must be removed and mulcher door must be closed.
TO ADJUST CUTTING HEIGHT
See “TO ADJUST CUTTING HEIGHT” in the Operation section of this manual.
TO ADJUST HANDLE
2 POSITION HANDLES
The handle can be mounted in a high or low position. The mounting holes in the bottom of lower handle are off center for raising or lowering the handle.
• | Remove upper handle and all parts at- |
| tached to lower handle. |
• | Remove hairpin cotters from lower |
| handle bracket mounting pin. |
HANDLE OVER
TO ADJUST HEIGHT
3 POSITION “EZ”
The handle on your lawn mower has three
(3) height positions - adjust to height that | |
suits you. | |
• | Remove knob and carriage bolt on one |
| side of the lower handle. |
• | While holding handle assembly, remove |
| knob and carriage bolt from opposite |
| side, align hole in handle with desired |
Install | Tab |
mulcher plug |
|
• | Squeeze lower handle in to remove it |
| from mounting pins. |
• | Turn lower handle over to raise or lower |
| handle. |
• | Squeeze lower handle in and position |
| holes onto mounting pins on handle |
| bracket. |
• | Reassemble hairpin cotters onto mount- |
| ing pins. |
hole in handle bracket and reassemble |
bolt and knob and tighten securely. |
• Align opposite side of handle with same |
positioning hole and secure with bolt and |
knob. |
High
Med.Bolt
Low
MOWER IS
Open mulcher door
Discharge deflector
• Reassemble upper handle and all parts |
removed from lower handle. |
Mowing | Mowing |
Handle adjustment
NOW READY
FOR MULCHING
OPERATION
“COMBI-CUT” MOWERS
Your lawn mower was shipped ready to be used as a mulcher. To convert to bagging or discharging:
REAR BAGGING
• Open rear door and remove mulcher plate. Store mulcher plate in a safe place.
•You can now install grass catcher.
•To convert to mulching or discharging operation, install mulcher plug into rear discharge opening of mower, making sure all tabs are seated properly.
position | position |
Hairpin | Handle | |
cotter | ||
bracket | ||
Mounting | ||
| ||
pin | HIGH POSITION | |
LOW POSITION |
bracket
Knob
10
19
