Poulan PR600Y21RP Table Of Contents, Safety Rules, I. General Operation, Ii. Slope Operation

Models: PR600Y21RP

1 14
Download 14 pages 51.61 Kb
Page 2
Image 2
TABLE OF CONTENTS

TABLE OF CONTENTS

Safety Rules

................. 2-3

Maintenance

16-18

Storage

25-26

Assembly

4-7

Service and

 

Troubleshooting

26-27

Operation

8-15

Adjustments

19-24

 

 

SAFETY RULES

IMPORTANT: This cutting machine is capable of amputating hands and feet and throwing ob- jects. Failure to observe the following safety instructions could result in serious injury or death.

TROUBLESHOOTING - See appropriate section in manual unless directed to an authorized Service Center.

PROBLEM

 

CAUSE

CORRECTION

Loss of power

1.

Rear of lawn mower

1.

Raise cutting height.

 

 

housing or cutting blade

 

 

 

 

dragging in heavy grass.

 

 

 

2.

Cutting too much grass.

2.

Raise cutting height.

 

3.

Dirty air filter.

3.

Clean/replace air filter.

 

4.

Buildup of grass, leaves,

4.

Clean underside of mower

 

 

and trash under mower.

 

housing.

SAFETY RULESLook for this symbol to point out impor- tant safety precautions. It means CAUTION!!! BECOME ALERT!!!

YOUR SAFETY IS INVOLVED.

PROBLEM WARNING: In order to prevent accidental starting when setting up, transporting, ad- justing or making repairs, always disconnect spark plug wire and place wire where it cannot come in contact with plug.

CAUSEWARNING: Engine exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. CORRECTIONWARNING: Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.

Loss of power CAUTION: Muffler and other engine parts become extremely hot during operation and remain hot after engine has stopped. To avoid severe burns on

contact, stay away from these areas.

I. GENERAL OPERATION

Read, understand, and follow all instructions on the machine and in the manual(s) before starting. Be thoroughly familiar with the controls and the proper use of the machine before starting.

Do not put hands or feet near or under rotating parts. Keep clear of the dis- charge opening at all times.

Only allow responsible individuals, who are familiar with the instructions, to oper- ate the machine.

Clear the area of objects such as rocks, toys, wire, bones, sticks, etc., which could be picked up and thrown by blade.

Be sure the area is clear of other people before mowing. Stop machine if anyone enters the area.

Do not operate the mower when bare- foot or wearing open sandals. Always wear substantial foot wear.

• Do not pull mower backwards unless absolutely necessary. Always look down and behind before and while moving backwards.

• Never direct discharged material toward anyone. Avoid discharging material against a wall or obstruction. Material may richo- chet back toward the operator. Stop the blade when crossing gravel surfaces.

• Do not operate the mower without proper guards, plates, grass catcher or other safety protective devices in place.

• See manufacturer’s instructions for proper operation and installation of accessories. Only use accessories ap- proved by the manufacturer.

• Stop the blade(s) when crossing gravel drives, walks, or roads.

• Stop the engine (motor) whenever you leave the equipment, before cleaning the mower or unclogging the chute.

• Shut the engine (motor) off and wait until the blade comes to complete stop before removing grass catcher.

• Mow only in daylight / good artifi cial light.

• Do not operate the machine while under the influence of alcohol or drugs.

• Never operate machine in wet grass. Always be sure of your footing: keep a firm hold on the handle; walk, never run.

• Disengage the self-propelled mech- anism or drive clutch on mowers so equipped before starting the engine.

• If the equipment should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibra- tion is generally a warning of trouble.

• Always wear safety goggles or safety glass- es with side shields when operating mower.

II. SLOPE OPERATION

Slopes are a major factor related to slip & fall accidents which can result in severe in- jury. All slopes require extra caution. If you feel uneasy on a slope, do not mow it.

 

DO:

 

• Mow across the face of slopes: never

 

up and down. Exercise extreme caution

2

when changing direction on slopes.

 

 

5.

Too much oil in engine.

5.

Check oil level.

 

6.

Walking speed too fast.

6.

Cut at slower walking speed.

 

 

 

 

 

Poor cut –

1.

Worn, bent or loose blade.

1.

Replace blade. Tighten

uneven

 

 

 

blade bolt.

 

2.

Wheel heights uneven.

2.

Set all wheels at same

 

 

 

 

height.

 

3.

Buildup of grass, leaves

3.

Clean underside of

 

 

and trash under mower.

 

mower housing.

 

 

 

 

 

Excessive

1.

Worn, bent or loose blade.

1.

Replace blade. Tighten

vibration

 

 

 

blade bolt.

 

2.

Bent engine crankshaft.

2.

Contact a qualified service

 

 

 

 

center.

 

 

 

 

 

Starter rope

1.

Engine flywheel brake is on

1.

Depress control bar to

hard to pull

 

when control bar is released.

 

upper handle before

 

 

 

 

pulling starter rope.

 

2.

Bent engine crankshaft.

2.

Contact a qualified service

 

 

 

 

center.

 

3.

Blade adapter broken.

3.

Replace blade adapter.

 

4.

Blade dragging in grass.

4.

Move lawn mower to cut

 

 

 

 

grass or to hard surface.

 

 

 

 

 

Grass catcher

1.

Cutting height too low.

1.

Raise cutting height.

not filling

2.

Lift on blade worn off.

2.

Replace blade.

(If so equipped)

3.

Catcher not venting air.

3.

Clean grass catcher.

 

 

 

 

 

Hard to push

1.

Grass is too high or wheel

1.

Raise cutting height.

 

 

height is too low.

 

 

 

2.

Rear of lawn mower

2.

Raise rear of lawn mower

 

 

housing or cutting blade

 

housing one (1) setting

 

 

dragging in grass.

 

higher.

 

3.

Grass catcher too full.

3.

Empty grass catcher.

 

4.

Handle height position not

4.

Adjust handle height to suit.

 

 

right for you.

 

 

 

 

 

 

 

Loss of drive

1.

Belt wear.

1.

Check/replace drive belt.

or slowing of

2.

Belt off of pulley.

2.

Check/reinstall drive belt.

drive speed

3.

Drive cable worn or broken.

3.

Replace drive cable.

 

4.

“Loose” drive control system. 4. Adjust drive control.

27

Page 2
Image 2
Poulan PR600Y21RP Table Of Contents, Safety Rules, I. General Operation, Ii. Slope Operation, Problem, Cause, Correction