FUNCTIONAL DESCRIPTION
Removing Battery Pack from Tool
Push in the release buttons and pull the battery pack away from the tool.
Fig. 2
1. | Front handle |
2. | |
3. | Trigger |
4. | Handle |
5. | Battery release buttons |
6. | Battery pack |
2
1
3 | 4 | 5 | 6 |
|
|
Inserting Battery Pack into Tool
To insert the battery pack onto the tool, slide the pack onto the body of the tool. Make sure it latches securely into place.
7. | Shoe |
8. | Lower guard lever |
9. | Lower guard |
10. | Blade bolt |
11. | Blade flange |
12. | Blade |
13. | Wrench |
14. | Bevel pointer |
15. | Bevel adjusting knob |
16. | Bevel scale |
17. | Rip fence adjusting knob |
18. | Depth adjusting lever |
8 7
Fig. 1
Inserting a battery pack
Selecting Blade
Removing a battery pack
3.Slide the lower guard lever up to raise the lower guard. Remove the blade from the spindle. Always clean the spindle, upper guard and lower guard to remove any dirt and sawdust.
NOTE: Do not remove inner blade flange. Larger diameter of inner flange (Fig. 3) should face the blade.
Fig. 3 Spindle | Bolt |
18
13
12 11
14 15
16
17
9
10
19.Upper guard
20.Rip fence slot
21.Sight line
22.Spindle lock button
19
20
21
22
Always use sharp blades. Dull blades tend to overload the tool and increase the chance of KICKBACK (see "Causes and Operator Prevention of KICKBACK"). Only use thin kerf blades with a maximum safe operating speed greater than the no load RPM marked on the tool's nameplate. Read the blade manufacturer's instructions before use. Do not use any type of abrasive
Installing and Removing Blades
1.REMOVE BATTERY PACK BE- FORE INSTALLING OR REMOVING BLADES.
2.Place the saw on a flat surface with the blade facing upwards. To remove the bolt from the spindle, push in the spindle lock button. While holding in the spindle lock button, use the wrench provided with the tool to turn the bolt clockwise (Fig. 2). Remove the bolt and blade flange.
Inner flange | Outer flange |
4.To install a blade, place the blade on the spindle with the teeth pointing in the same direction as the arrow on the lower guard (Fig. 4). Release the lower guard lever.
Fig. 4
TOOL ASSEMBLY
5. Place the blade flange on the spindle |
and hand tighten the bolt. |
WARNING
Recharge only with the charger specified for the battery pack. For specific charging instructions, read the operator's manual supplied with your charger and battery pack.
WARNING
To reduce the risk of injury, always remove battery pack before chang- ing or removing accessories. Only use accessories specifically recom- mended for this tool. Others may be hazardous.
6. While holding in the spindle lock button, |
use the wrench to turn the bolt counter- |
clockwise and tighten. |
6 | 7 |
