OPERATION
The operation of any tiller can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields before starting your tiller and while tilling. We recommend a wide vision safety mask for over spectacles or standard safety glasses.
00155
HOW TO USE YOUR TILLER
Know how to operate all controls before adding fuel and oil or attempting to start engine.
STOPPING (See Fig. 6)
TINES
1. Release tine control to stop movement.
ENGINE
2. Move throttle control to "STOP" position.
TINE CONTROL |
“OFF” (UP) POSITION |
TINE CONTROL |
“ON” (DOWN) POSITION |
THROTTLE |
CONTROL |
Fig. 6
TINE OPERATION (See Fig. 6)
•Squeeze tine control to handle.
TILLING
The speed and depth of tilling is regulated by the position of the depth stake.
The depth stake should always be below the wheels for digging. It serves as a brake to slow the tiller’s forward motion to enable the tines to penetrate the ground. Also, the more the depth stake is lowered into the ground the deeper the tines will dig.
DEPTH STAKE (See Fig. 7)
Adjust depth stake by removing the hairpin clip and clevis pin. Change depth stake to desired position. Replace the clevis pin and hairpin clip.
•For normal tilling, set depth stake at the second or third hole from the top.
DEPTH
STAKE
HAIRPIN
CLIP
CLEVIS PIN
Fig. 7
TO TRANSPORT
CAUTION: Before lifting or transport- ing, allow tiller engine and muffler to cool. Disconnect spark plug wire. Drain gasoline from fuel tank.
AROUND THE YARD
•Adjust depth stake so clevis pin is in bottom hole.
•Push tiller handles down, raising tines off the ground.
•Push or pull tiller to desired location.
AROUND TOWN
•Disconnect spark plug wire.
•Drain fuel tank.
•Transport in upright position to prevent oil leakage.
7
