NOTE: When performing the following step, be sure the starter rope is not caught under the cable clamps. The starter rope must hang freely to operate properly.
Cable clamps
Starter rope
Throttle
cable
7.Align one cable clamp above the tube bolts and the other below the starter rope han- dle. Install the cable clamps one at a time around the tube and throttle cable.
NOTE: Ensure throttle cable is in groove of clamps and lies flat against the upper handle tube after installation (see illustration above).
OPERATION
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Throttle Trigger
Starter Rope Handle
Choke Lever
| Shield |
|
| ON/OFF |
|
| Switch |
|
Upper Handle | Primer Bulb | Muffler |
|
Lower Handle
Trimmer Head
Shield
ON/OFF SWITCH
The ON/OFF switch is used to stop engine. To stop the engine, move the switch to the OFF position.
PRIMER BULB
The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.
CHOKE
The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. After the engine attempts to start, move the choke lever to the HALF CHOKE position. Once engine has started, move the choke lever to the OFF CHOKE position.
4
