Powermate PM0675700 manual Major Generator Features, Receptacle Cover Installation, Control Panel

MAJOR GENERATOR FEATURES RECEPTACLE COVER INSTALLATION

*10 HP Yamaha OHV engine

*Low oil sensor

*6.5 gallon plastic fuel tank

*Receptacles on control panel

*CordKeeper™

*Portability Kit

CONTROL PANEL

NOTE: Total power drawn from all receptacles must not exceed the nameplate ratings.

A.120 V, 20 Ampere Duplex Receptacle

20 amps of current may be drawn from either of the duplex receptacles. However, total power drawn must be kept within nameplate ratings. These receptacles may be used along with the twistlock receptacle provided the generator is not overloaded.

B.120/240 V, 30 Ampere Twistlock Receptacle

Maximum full load current may be drawn from the 120/240

volt receptacle, provided it is the only receptacle used. Total current must be limited to the nameplate rating. If the 120/240 volt receptacle is used along with the 120 volt receptacle, the total load drawn must not exceed the nameplate ratings.

C.Circuit Protectors

The receptacles are protected by an AC circuit protector. If the generator is overloaded or an external short circuit occurs, the circuit protector will trip. If this occurs, disconnect all electrical loads and try to determine the cause of the problem before attempting to use the generator again. If overloading causes the circuit protector to trip, reduce the load. NOTE:

Continuous tripping of the circuit protector may cause damage to generator or equipment. The circuit protector may be reset by pushing the button of the protector.

D.Engine On/Off Switch

E.Oil Warning Light

F.CordKeeper™ Restraint

The CordKeeper™ restraint is a unique feature used to

prevent plugs from being pulled out of the receptacles.

Instructions are included with the receptacle cover kit.

CORD SET

Your generator is supplied with a 25 foot 12 GA SJTW 4-conductor 105ºC power cord set. This cord is equipped with an L14-30P twistlock Plug, on one end, which will plug directly into the mating twistlock receptacle on the control panel of your generator. The opposite end comes equipped with a special 4 circuit connector comprised of four 5-20R receptacles. These may be used to power individual loads. NOTE: For 120 volt use only. Make sure the loads do not exceed the 20 amp rating of the Power Cord Set. Circuit breaker protection is provided for on the control panel of your generator.

You will notice that the 4-circuit connector is color coded with gray and yellow receptacles. When several loads are powered at the same time, it is best to keep equal loads supplied to each separately colored half, if possible. The gray half and the yellow half of the connector are each capable of sustaining 20 amps of current provided your generator is capable of supplying 4800 watts of power. Check nameplate ratings for total wattage capability of the generator.

	English
2